Hesitates from standing start and bucks at highway speeds when accelerating.
SOURCE: Location of blower motor switch resistor on 2004 Grand Marquis
The blower speed controller is located under the hood on the right or passenger side on the heater housing just to the side of the heater hoses near the very back of the right cylinder head.
Yes that would cause the concern you are having.
SOURCE: rear shocks on a 1996 Mercury Grand Marquis
Raise car under frame then put jack under axle before removing the shock.
Can use locking pliers to hold the shaft from turning (may have to cut away dust boots). Top nuts are accessed and can be seen from the wheel wells or from the gap between the trunk and mount frame (can't see nut from this angle). Take care with fuel lines near the driver side nut.
Preventing shafts from turning on new shocks will be tough. Make sure you have a proper tool to fit top of shaft with enough room between top of shaft and trunk (gap decreases as the nut is tightened) so the tool can be removed.
SOURCE: where are the spark plugs located on a 2000 Mercury Grand Marquis
There are eight COPs (coil-on-plugs) to remove. Using a 7mm or 9/32" socket, remove each bolt securing each COP to the intake manifold on top of the engine. Remove all eight COPs, and the spark plugs are underneath. When replacing the spark plugs, use only the proper Ford/Motorcraft plugs, even if they cost twice as much as the aftermarket ones. You will avoid further headaches this way. Hope this helps.
SOURCE: how to replace starter +1993 Mercury Grand Marquis
disconnect battery,,jack car up,,put jack stand on frame,,take starter bolts out,(may not be easy),,take wires off starter,,hoped it helped,,
551 views
Usually answered in minutes!
×