For instance last night started ran for five or so minutes put it in gear to leave shut rite down.went and picked it up this morning started and ran fine.
If the crank sensor is failing, you should get a check engine light and a trouble code for it.
Have you had the computer checked for trouble codes ?
SOURCE: jeep keeps blowing auto shutdown fuse
Yes I had the same problem. The wires that plug into the sensor at the catatytic converter were rubbing against the drive shaft untill they finally wore through causing the short against drive shaft. repaired wires and it fixed everything
SOURCE: 93 grand cherokee 5.2 all time 4wd wont stay runing when put in gear
It sounds like the torque converter is locked up. Possible a bad torque converter or converter solenoid. First thing you should try is unplugging the solenoid plug on the transmission. Drivers side, near the shifter. Not the three pin connector near the pan on the same side. The connector you want is higher than the reverse light plug.
SOURCE: 2001 jeep grand cherokee 4.0 engine shuts off
it is possable/likely a bad ECTS (engine coolant tep. sensor), this can cause the injectors to allow to much fuel into cylinders and cause a low compression and or flooding situation, good luck, marty
SOURCE: 95 honda accord turns over but wont start
Sometimes when a fuel filter is stopped up,and you change it,the fuel pump later,will go out,cause of the strain on the pump.
Testimonial: "THanks for your help!!! and thoughts.. ended up replacing distributor and now car is starting!!!"
330 views
Usually answered in minutes!
×