They are always on when the truck is running. I can't go to a drive in movie...I've tried the emergency brake, holding this in, pulling on that, tapping the brake...all suggested by my ford mechanic and the local police, but no luck. Please help!!!
Pull the fuse.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
SOURCE: location of air conditioner low pressure valve
The low pressure valve on the 01 expedition is located on the accumulator on the passenger side fire wall. The accumulator is underneath the battery relay and a grouping of wires. Had to squeeze hand underneath a heater hose and an a/c line to remove cap and hook up hose. Nothing has to be removed to locate the valve just a little touchy feely. Valve faces a 45 forward toward the engine.
SOURCE: diagram bypass heater cord on 2001 ford expedition eddie bauer
the heater bypass is quite simple, if you look at the firewall you will see two medium sized coolant lines, remove them from the firewall and link them together using a proper sized tube, you can purchase a kit at a parts store quite cheaply
SOURCE: Oxygen Sensor Location 2001 Ford Expedition Eddie Bauer
There are four o2 sensors on this truck. one on each side just below the exhaust manifold, and one on each side behind the second catalytic converters. (just about even with the back of the front doors.
SOURCE: How do I install a brake booster on a 2003 Ford
disconnect the neg batt cable,loosen clamp and disconnect air cleaner outlet tube and resonator from the air cleaner. 2.disconnect maf sensor connector. 3.lift air cleaner assy from tray and position aside. 4. remove screws from power steering resevoir, and position aside. 5.disconnect brake fluid level sensor, and if equiped brake pressure switch. 6.remove the two mounting nuts holding master cylinder, position master cylinder aside (DO NOT LOOSEN LINES ON MASTER CYL). 7.remove mounting bolts for degas bottle and postion aside. 8.if equiped diconnect wiring at the pedal position sensor. 9.relaease clamp and disconnect hose. 10.remove the pin, washer, bushing and switch, disconnect pushrod. 11.remove the nuts and brake booster, to access nuts fold back sound insulation. reverse procedure to install.
Testimonial: "Dude, you rock. Thanks for the info. I have done a lot of radiators, alternators, even a knock sensor on a maxima, but never this......thanks bro."
SOURCE: i have 98 eddie bauer ford explorer with headlight problems
The headlamp switch will cause the lamps to turn off. The switch heats up and turns the headlamps off. It will cool down and work for about 10 minutes and cut out,
151 views
Usually answered in minutes!
×