2007 Subaru B9 Tribeca Logo

Related Topics:

A
Anonymous Posted on Aug 08, 2012

Replacing the drivers windows switch on a 2007 tribeca

Drivers side window switch needs replaced

5 Related Answers

Anonymous

  • 375 Answers
  • Posted on Jun 24, 2008

SOURCE: need to replace drivers side mirror

not so difficult , there should be a piece of trim straight in from mirror on inside of door, remove trim behind should be nuts holding mirror on.

Try partstrain.com they sell aftermarket replacement parts, mirrors look like origionals but alot cheaper

Ad

Anonymous

  • 23 Answers
  • Posted on May 07, 2009

SOURCE: Subaru Outback 2005 - Driver side door/window

The switches in Subarus are made by Nissan believe it or not. They are not interchangeable. Anyway, I suspect you have a bad window switch. You can pickup the whole bank of swiches or replace just the one. Do a search on ebay for your part.
Has this car had body damage on the driver's door? You could have a cut wire inside the door.

Anonymous

  • 119 Answers
  • Posted on Jul 30, 2009

SOURCE: Driver's side window doesn't work

i would make sure the master switch is not the problem,make sure power and ground are supplied to the motor from the switch you'll need a test lamp,the light should come on by probing at the motor connector,light willcome onup position ,other pole will light in down position,no light ,no power bad switch good luck

freetek

Steve Allison

  • 5569 Answers
  • Posted on Nov 03, 2009

SOURCE: how to replace power window switch on 2005 subaru,

The Haynes service manual (#89101) shows the window switch panel is only retained by tensioners that are part of the panel and that the method of removal is to carefully pry the entire panel out of its mounting hole. Once the panel is clear of its home, the switch appears to also be only pressed into the panel seat. I think you will find that the switch has 'quick disconnect' connectors that will pull off and plug onto the new switch.

Anonymous

  • 377 Answers
  • Posted on Nov 15, 2009

SOURCE: How to Replace power window switch on driver side,

with the panel removed ,the switch comes out as a complete assembly..

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My 2007 vw eos drivers window won.t close,all others works fine

Could be the master switch because the drivers window is mostly used, or the window motor/regulator. same reason. Easy to check with a volt/ohm meter. You'll need wiring/pin outs for electrical.
0helpful
1answer

Toyota corolla side window

The driver switch is called the master switch. When replacing this unit you need to perform what's called a ( relearn ). Turn the ignition switch to position 2 so that the dash lights come on. Then hold the window switch in the down position and keep holding it down for 10 seconds after the window is all the way down. Then make the window go fully up and hold the bottom up for 10 seconds after the window closes . Sometimes you my need to do this a few times to make it relearn . This performed properly should give you full operation of the windows. FYI. This may need to be done on every door. . This will also need to be done if you replace a window regulator of any door or door windows you replace.
Hope this helps. Mr Toofix
0helpful
1answer

2007 B9 Tribeca haedlamos keep going out after replacement....last about 1 week tops...and noI am not handling the bulb with my hands

I just spent five hours replacing the passenger side bulb because I did not know to leave the spring alone. I then replaced the bulb and when I went to check the headlight, the drivers side blew out. 5 minutes job turned into five hours.
0helpful
1answer

Passenger electric window switch broken on drivers side,press switch on passenger side up or down window dosent move,does it need to have the wiring altered being as the switch on the drivers side is...

The main control switch on the driver door may need replacing, first check and see if the wires to the passenger control on the main switch is properly connected
1helpful
2answers

VW Polo 2001 - Electric Windows wont open from Drivers side..

I removed all 3 switches from driver and passenger door, which is really easy with a flat head screw driver. took them completely apart, very carefully, with a small screwdriver out of a christmas cracker. put them back together again and 2 switches started working, so I put 1 in the drivers side and 1 in the passengers side so now my drivers door window opens and I lean over to open the passenger door. cool, no money spent...yet ;o)
0helpful
1answer

Drivers side power window switch

I would start by replacing the switch cluster.
Not finding what you are looking for?

1,424 views

Ask a Question

Usually answered in minutes!

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...