Removal engine oil sump ,how?
SOURCE: Have Mazda bravo B2600 4WD ,has white smoke &
You dont say weather its a petrol or diesel engine as there a slight differance in the answer and if a turbo on a diesel thats even more of a differance, but taking it a petrol .
Well to start with the white smoke Isent smoke its water and after going through the engine it turns into Steam and thats what you see..
Running on 3 clyinders is caused through 1 cylinder isent working as a engine should and has a bad valve or a broken piston ring or more and even a cracked head and gasket letting the water through,,,also the broken ring works like a oil pump as if not firing given you power then it works like a oil pump and pumps it into the cylinder that dosent work only pumping oil into the hot exhaust system while running.CAUSING SMOKE
And if a turbo then could be the turbo bearings worn and pushing oil into the engine and still doing the same as before.
Let me know how you get on. RON
SOURCE: changing gearbox oil ?
i accidently drained some of the gearbox oil from my bravo b2600 1997. where is the hole to put more fluid back in there? how much should i put? and what fluid should i use?
SOURCE: i need to set up the camshaft timing marks on a 1994 mazda b2600
its not just the camshaft timing marks you set up, you also have to have the crankshaft timing mark set right to or you may damage your engine
check the internet for the right timing procedure for you model car ok
SOURCE: not sure how to remove a driveshaft from a 91 ext.
Welcome to FIxYa.com
REMOVAL AND INSTALLATION Remove in the order shown in the figure. Install in the
reverse order of removal. I Image 1. Nut 2. Lock washer 3. Bolt 4. Nut 5. Nut 6. Lock washer 7. Bolt 8. Nut 9. Washer lo. Nut 11. Lock washer 12. Bolt 13. Rear propeller shaft Propeller shaft (4x2) Before removing the propeller shaft, mark the flanges for
correct installation. Propeller shaft (4x4) Before removing the propeller shaft mark on the front, and
rear side flanges for correct installation. (4x2 Model) When the propeller shaft is removed from the extension
housing, immediately install the SST into the extension housing to prevent oil leakage B2200: 490259440 B2600i: 49 5120 440 1m a Propeller shaft 1. Align the marks. And install the rear propeller shaft. Tightening torque: 49-59 N.m (5.0-6.0 m-kg, 36-43 ft-lb) 2. Install the center bearing support assembly. Tightening torque: 36-53 N.m 3.7-5.4 m-kg, 27-39 ft-lb) 3. Align the marks, and install the front propeller shaft. Tightening torque: 49-59 N.m (5.0-6.0 m-kg, 36-43 ft-lb) Thank you for using FixYa.com Regards, Lee Davidian
SOURCE: 1998 mazda bravo ute b2600 petrol- Cannot locate
No!!!! The motor has oil filter.Look from the top of the motor.It is right there.Under the manifold.Hope this helps
Fig. Fig. 1: 2.2L Engine Engine Firing Order: 1-3-4-2 Distributor Rotation: Clockwise 
Fig. Fig. 2: 2.6L Engine Engine Firing Order: 1-3-4-2 Distributor Rotation: Clockwise
204 views
Usually answered in minutes!
×