SOURCE: i need to set up the camshaft timing marks on a 1994 mazda b2600
its not just the camshaft timing marks you set up, you also have to have the crankshaft timing mark set right to or you may damage your engine
check the internet for the right timing procedure for you model car ok
SOURCE: not sure how to remove a driveshaft from a 91 ext.
Welcome to FIxYa.com
REMOVAL AND INSTALLATION Remove in the order shown in the figure. Install in the
reverse order of removal. I Image 1. Nut 2. Lock washer 3. Bolt 4. Nut 5. Nut 6. Lock washer 7. Bolt 8. Nut 9. Washer lo. Nut 11. Lock washer 12. Bolt 13. Rear propeller shaft Propeller shaft (4x2) Before removing the propeller shaft, mark the flanges for
correct installation. Propeller shaft (4x4) Before removing the propeller shaft mark on the front, and
rear side flanges for correct installation. (4x2 Model) When the propeller shaft is removed from the extension
housing, immediately install the SST into the extension housing to prevent oil leakage B2200: 490259440 B2600i: 49 5120 440 1m a Propeller shaft 1. Align the marks. And install the rear propeller shaft. Tightening torque: 49-59 N.m (5.0-6.0 m-kg, 36-43 ft-lb) 2. Install the center bearing support assembly. Tightening torque: 36-53 N.m 3.7-5.4 m-kg, 27-39 ft-lb) 3. Align the marks, and install the front propeller shaft. Tightening torque: 49-59 N.m (5.0-6.0 m-kg, 36-43 ft-lb) Thank you for using FixYa.com Regards, Lee Davidian
SOURCE: how do i remove timing cover off 89 mazda b2600
put a rope to the car and toll it to the nearest scarp yard and burn the mazda
SOURCE: 1998 mazda bravo ute b2600 petrol- Cannot locate
No!!!! The motor has oil filter.Look from the top of the motor.It is right there.Under the manifold.Hope this helps
117 views
Usually answered in minutes!
×