Changed fuel pump and now we have fuel
SOURCE: The truck won't start, Fuel
Fuel pump replaced, crank sensor replaced, coil, wires and plugs all replaced, now truck acts like it's flooding out and won't continue to run.. problem started with truck shutting itself off while driving. you could let it sit and cool off and it would restart but only for a few minutes..
SOURCE: 1989 Honda Prelude won't start
I suspect that your spark plug wires or your distributor is going out. Check your spark wires and distributor. To do that take out #1 spark plug wire from the spark plug. Next take out your spark plug then put it in the spark plug wire. Then turn on car and take a look at the spark plug to see if it's getting a spark. Do this with all the spark plug. If it is your spark plug wire I would replace all of them.
SOURCE: location of speed sensor a for 99 dodge intrepid
The "Vehicle Speed Sensor" signal is generated by the transmisson output speed sensor. That is the one located at the rear of the case. It is externally mounted. That supplies "vehicle speed" info to the other On-Board Computers. The input turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info and it is located on the bell housing near the engine block. I hope this helps.
SOURCE: My 1999 dodge intrepid is trying to start but wont fire up
try the crankshaft sensor. it is on the transmission bell housing on the passenger side. You could also check for codes by turning the key to the on then off 3 times (DO NOT START THE ENGINE) and it will give you any stored codes in the mileage display
SOURCE: My chevy express van 1500 cranks but wont start
test and see if you have spark and fuel preasure, you may have bad feul pump, common problem is the fuel pump goes bad, but check before replacing.
112 views
Usually answered in minutes!
×