SOURCE: need to know how to
To check the timing or replace the timing belt? Well, in any case, It would be to hard to tell and show you over the computer.
The best and easiest way for you is to buy a Chilton manual for your car at the autoparts store. The book runs about $20
This book is a do-it-yourself bible. It will show you everything you need to know on how to do maintenance and repair on your vehicle.
SOURCE: how to put on ignition switch on a '88 mazda b2200
If you mean actually replacing the ignition switch on the vehicle with a locking column. You need to do this. Dicconnect the battery, remove the lower panel of the dash if there is any. There is a bolt on the steering column near the fire wall on most vehicles, remove this bolt, it will release the spline on the steering column. Disconnect all wiring going to the column, unbolt the column from the dash support. Remove the column from the truck, on the ignition switch you will see where the two shear bolts screw the assembly together, center punch the center of each bolt. Now drill the bolt with a 1/8" drill about 1/4" to 3/8" deep. Now use a 3/8" drill and drill out the shear head until it comes off the bolt. You can now remove the switch assembly from the column. The new assembly should come with new shear off bolts so when you bolt it in place when tightned they will break off rendering it tamperproof again. Most vehicles are designed like this now to stop theft. Check the column for operation before reinstalling it in the reverse of above. You just want to make sure the key locks and unlocks the column before reinstalling in the vehicle. You may want to do this before you totally tighten the bolts and break them off permanently. Good luck, RAC
SOURCE: How do you change the starter out of a 88 mazda
first things first make sure you unhook you battery then mark all the wires to your starter as you are removing them. remove the starte.then put its all back the way it was.
SOURCE: price on a 1991 B2200 Mazda Pickup truck carburetor
Depends if you want new or used, Location, and a few other variables
SOURCE: how do i disasemble a
http://www.mazdatruckin.com/B2200/Differential_Swap.html
this will walk you through it
Colin
247 views
Usually answered in minutes!
×