When I start my truck it seems fine, when I put it in drive it idols low, when I attempt to drive it it will have a hard time in a low gear and stall, higher gears work fine. If I put it in reverse it stalls immediately, any help would be appreciated. I am thinking it could be the IAC but would like some more input from someone that may have had this issue before
SOURCE: stalls when put into gear
Its possible it could be other things causing the problem, but seeing as you've checked most of the likely causes, it is most likely your Torque-Converter. The lockup clutch in your Stator-Fan located inside the Torque-Converter could be siezed, causing the car to stall.
SOURCE: 2000 ford explorer 4.0 x-engine is stalling, missing and lose power while driving
Exhaust might be stopped up. Check the catalytic converter and or muffler.
Good luck!
SOURCE: 302 engine starts fine but shuts off when put in gear to pull out.
check the idle air bypass solenoid
SOURCE: 1998 ford explorer stalls when driving, have to wait 30 minutes
possible fuel pump. Try spraying starting fluid into breather while someone is cranking engine. if vehicle tries to run it is fuel problem. If not it could be an electrical componet overheating and cooling and restarting. Coils, relays, ecm.
353 views
Usually answered in minutes!
×