Where is the crankshaft position sensors on a 1995 cadillac sts seville with a northstar engine?

SOURCE: Need to replace both crankshaft position sensors 2001 Cadillac

4.6 the twocrankshaft position sensors are located on the front of the block just above and to the left of the oil filter. not hard to replace.

SOURCE: replace power steering pump and lines 1992 cadillac seville sts

you need to have a pulley puller to get the pulley off if you don't have one most auto zone part stores have a loan a tool program and they can help you with that on most powersteering pumps the high pressure line will be a fitting or bolt on and the return line is usually just a squeeze clamp hope this helps good luck

SOURCE: I have a 94 cadillac seville sts, end I have a

First thing you have to do is list all the codes, because some some might be stored for a long time. Pushing the OFF and WARM buttons together and holding will ghive you all the stored codes. Then press OFF and HI together to clear all codes. Hold and wait for bars or 0's. Now start your car and let it get up to proper operating temps. Take car for aride that aincludes all phases of driving including highway speeds. Observe SERVICE ENGINE LIGHT for coming on . Assuming it does , repeat steps previously provided, read codes stored and repair accordingly. If need be contact me with new codes and I will try to assist you.

SOURCE: How do I R&R front motor mounts on 2000 cadillac sts

Very easy, just remove front tires and unbolt, BUT I doubt you are asking right question. Not mounts, but mount in dead front center is problem. There are 4 mounts, transmission center back, left center and right center and front center. That takes full torque of motor and heat from exhaust. GM has a shield for exhaust.

SOURCE: where are the camshaft and crankshaft position

crankshaft sensor is and the hormonic balance pulley and cam sesoor should b and the front of the motor toward the top. But to b sure u should get a book for u vehical