Can't find where the relay is located. Both signals and hazard lights light up, but no flashing. Tried working the multifunction switch on top of column, but did not make a difference.
Hi there:
I suggest to look behind glove box, drop door all the way down (black square box).
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.
Thank you for using FixYa, have a nice day.
SOURCE: 1992 Ford Ranger Turn signal/Hazard light issue
Can you just check to make sure the ignition key switch is not staying over to far and not backing off when you try to start it. I had a truck that did that and it messed up my turn signals until I brought the key switch back a little after starting it. Just a simple idea. Be kind with your rating for me. Raz
SOURCE: where is the turn signal\hazard flasher located?
it's in the auxiliary relay box behind the glove box.
13350 is base part number on flasher
Testimonial: "Actually found it located behind the radio mounted on a brace. Removed cover and relay pulls out. About 1" cube with 5 terminals on it."
SOURCE: Cannot locate flasher for 1994 ford crown victoria
The flasher is the round most likely yellow but could be silver mounted in fuse panel. The hazard flasher is located on back side of fuse panel directly behind it.You can remove it and insert it in place of the turn signal flasher to see if it is bad.
SOURCE: signal lights and hazard lights don't flash 1998 Ford Cotour
Check inside steering colum case.
SOURCE: '96 ford Crown Victoria....No hazard or brake light no turn sigal
Sounds like the multifunction switch. Try working the hazard switch up and down a few times to see if you get some lights to work. If so then replace the switch.
2,200 views
Usually answered in minutes!
×