2002 chevy silverado 1500 extended cab has a electrical problem

These vehicles were known for faulty hazard switches. They would cause an intermittent turn signal flash when you hadn't activated turn signals or they would prevent the turn signals from working at all. Operate the hazard switch and see if the turn signals work again. If so, replace the hazard switch

Those wires are to prevent static buildup on the hood. This buildup causes static noise on the audio system when driving. Also those straps are used for ground on the engine compartment light.

jack up rear of truck and secure it put trans in neutral and go under vehicle and move driveshaft up and down and spin it back and forth see if there is any play the reason for jacking it up is to relieve pressure on the driveline without weight of vehicle on it

Chevrolet Silverado 1500 Questions - Where is the reset ...

www.cargurus.com > Questions > Chevrolet > Silverado 1500

CarGurusWhere is the reset button for the gas on a 2002 chevy silverado - Please answer. ...Asked by Angie Feb 09, 2013 at 05:31 PM about the 2002 Chevrolet Silverado 1500 ...When you say "gas" the security system shuts off fuel to the injectors.

Electric fuel pump diagnosis: Houston, we have a problem ...

www.autoserviceprofessional.com/.../electric-fuel-pump-diagnosis-houst...

Posted on April 11, 2013 by Mike Mavrigian - Also by this author ... If the vehicle was involved in a collision, impact sensors can kill the pump signal, as well as ... can cause fuel pump intermittent or shut-off problems, when the oil pressure sensor ... 38 fuel lineon my 67 Chevy small block why do I still get fuel pressure drop.Missing: 1500

Impact Cut Off Switch For Fuel Pump? - Ask the GM Technician - GM ...

www.gm-trucks.com > ... > Ask the GM Technician

Apr 7, 2009 - 8 posts - ‎6 authors
posted in Ask the GM Technician: New to the Chev pickup scene. ... Silverado 2500 HD truck would have an impact switch to cut off the flow of fuel to ... Reason for looking at the fuel shut off option was for simplicity on my part. ... your truck is a GMT800 it has a chip & sensor in the key tumbler if its a GMT900 ...

[PDF]Owners Manual - Chevrolet

https://www.chevrolet.com/.../Chevrolet/.../2k13equinox.pdf Chevrolet

How to fix the Chev power window door lock switch - YouTube

? 5:04
https://www.youtube.com/watch?v=XDKaDURD8Sc
Jul 13, 2013 - Uploaded by spelunkerd
How to fix the Chev power window door lock switch ..... Some time later my drivers side window stopped working in the down position. ... These intermittent electrical problems are frustrating,aren't they? .... How To Install Replace Door Locks Chevy GMC Truck Silverado Sierra Yukon Tahoe Suburban ...

Diagnose Power Door Locks Dont Work Properly - Auto ...

www.auto-repair-help.com/.../diagnose_power_door_locks_dont_work_...

An inoperative power door lock can be caused by the switch, solenoid, wiring problem or ... Hi, I have a 2005 Nissan Sentra and the power locks aren't working. .... Hi, mypassenger door locks/unlocks both doors but my driver side door works independently and .... I have a 1986 Chevy Silverado K10 with auto door locks.

SilveradoSierra.com • 2003 silverado no power in right door ...

www.silveradosierra.com/.../2003-silverado-no-power-in-right-door-t30...

-Check "headLight fuse"
-Check connector at the headlight.
-Check the bulb. (It could burn out)

Mai

This is a well known issue with model years 2003 thru 2005. There is a chance GM will replace it under recall... Call the Chevy Customer Assistance Center 1-800-630-2438 to find out.

If not and you want it fixed, try Southern Electronics at http://www.instrumentclusters.com/.

follow the pipes from the cat forward, you shld be able to find them. from the cat down or back, would be your rear sensors.

you can order it at some dealer ships . it cost about 150.00 dollars or more.

Presumably an electric window? Stand outside truck with door open and hold the window between your palms. Gently lift the glass to a closed position while someone activates the control (with engine running). You should be able to determine if the glass is jammed (moving glass slightly backward and forward should aid movement) or if a little hellp makes the window move easily.

If the window appears jammed, it could be off the track. A repair would require removal of the door panel.

If the window appears to only require help to close, your door motor could be getting weak or some how the window track could be causing a bind.

At least you should be able to get the window closed.

good luck.

KK