2008 Audi A3 Logo

Related Topics:

A
Anonymous Posted on Jul 31, 2012

Audi A3 ESP fault

ESP Fault popped up. Now it wont start.

4 Related Answers

Larrysito

L.K.Computers Ltd

  • 73 Answers
  • Posted on Aug 30, 2009

SOURCE: Audi A4 ESP problem

loss of power sure car is breaking !!! some of the abs sensor broken or dirty

Ad

Anonymous

  • 107 Answers
  • Posted on Sep 23, 2008

SOURCE: Audi a3 rear brake light fault

the dealer can fix this or any mechanic with a vag com interface, basically its a matter of programing the tailgate lights (both of them) to work as brake lights. the euro speck enables one of the other or both, same goes for the backup light. if you had a module replaced recently this could be the reason for the change, whoever installed it should be able to rectify this for you.

Anonymous

  • 1 Answer
  • Posted on Sep 14, 2009

SOURCE: My Audi A3 2.0 tdi limp mode/turbo overboost

i also have done a diagnostic test and it states a turbo overboost condition and it drives fine locally but loses power on the motorway and struggles to reach 80mph? any suggestions please email me at [email protected]

Anonymous

  • 2 Answers
  • Posted on Nov 22, 2009

SOURCE: i have audi a3 05 when starting feels like no

VW engines intend to do this, even if you pull up at a set of traffic lights it will nearly cut out or go into high rev's. i have an a3 & once driving down the road @ about 50kpm, I lost power stearing for 1-2 seconds, stearing wheel went stiff. Audi are a good drive but needs lots of tlc. One other thing is fuel pump could be acting up a bit.

Testimonial: "will look into that thankyou"

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2006 audi A6 ESP light problem ESP light comes

A good place to start is the brake light switch.
There are 2 circuits in there: 1 for the brake lights and the other for the car computer (ESP, Engine brake etc...)
If the brake switch has an intermittent fault, the EPS light may come on and the car may run rough until you stop the vehicle and remove the key. It then re-set itself until the next time you are using the brakes and the fault appears again.
0helpful
2answers

How did get my esp light to go off, on my 2006 audi a6.

When the light stays on it indicates a fault is occurring in the system. In order to repair this you first need the control module scanned for fault codes and then careful diagnosis will reveal the failed part.
0helpful
1answer

Audi a3 1.6tdi fault code p261a

Got my 2011 audi a3 1.6 tdi se hooked up to a diagnostic machine last night and these were the fault codes that came up _ 01500, 00927, 00979 AND 01499. I KNOW IT'S TO DO WITH THE LIGHTING CIRCUITRY BUT WHAT DOES IT RELATE TO IN REPAIRS?
0helpful
1answer

ESP FAULTY

will be a good IDEA to RUN the scanner/computer for easy diagnostic and fix it. The electronic now in vehicles is very complicated. Do not waste time+money.
However if you want to go www.autoelectronico. com and translate this amazing website, with your browser and try to fix it.
God bless you
0helpful
1answer

Hi i have audi a3 tdi. 2. car and there is a indication of soot while i am drving the car and i lost the power now car wont start , can u tell me the how can i avoide that kind of indications and how

Soot builds up in the vehicle's exhaust system and can trigger this kind of behavior. This typically happens when the vehicle is used in an urban setting a lot, and rarely is driven on the highway. You may need to have the vehicle's exhaust examined, and cleaned if possible.
This is a typical fault with most modern diesel cars.
0helpful
1answer

My audi a3 2.0 tdi has cut out and wont start seems like it is turning over realy easy it has done 53k there is and was no fumnny noises there is no warning lights or anything

I would suggest that you scan the computer for fault codes. There are different sensors that control ignition and fuel and any one of these sensors can cause the car to stall and refuse to start. The crankshaft positioning sensor could be the cause if it has failed completely. The check engine light may be burned out , therefore no warning lights.
2helpful
1answer

I have a 2000 Audi TT Quattro (180). Both my ABS and ESP light were on. I took it to my local garage who replaced a front wheel sensor which eliminated the ABS light. After a 30 mile drive the ESP light...

Check bearing and joint/knuckle on every wheel and even on the drive shafts, if there is lack/knocking, that could cause abs and esp light, because sensor doesnt give right information and ecu only records sensor fault but doesnt say why the infromation is wrong.
They changed the sensor but didnt solve the cause!!!
1helpful
1answer

ESP and ABS warning lights are both on and will not reset by switching off/restarting. Can they be reset by other means?

they wont go out if there is a fault iin the abs or esp get it plugged into a code reader and it will tell u what the fault is and clear the fault
1helpful
1answer

Audi TT 1.8 petrol 2000. Removing ESP switch on dash, are there any know tips? Regards ****

The ESP light has come on due to a fault with the abs/ traction system . It will req fault code reading by a diagnostic tester to determine the fault more than likely a abs wheel speed sensor.
Not finding what you are looking for?

536 views

Ask a Question

Usually answered in minutes!

Top Audi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...