While driving the engine dies/stalls. rpm to 0, but radio, lights, A/c don't seem affected. It will try to start but will take 20+ minutes til it will start. I have replaced battery, cam & crank sensors, fuel pump, air filter, oil change, sprayed throttle body intake with cleaner, don't see any damaged wires, and had dealer replace and program computer/ecm. Still stalls. Why?
SOURCE: My 1993 Nissan Sentra GXE
Have you checked your MAF? Sentra's are famous for them having problems, I havent had an issue with mine yet thank god.
SOURCE: 2004 1.8l nissan sentra what now? not battery or fuel pump/filter
Check your catalytic converter. If you are over 80k miles, these devices will wear in stages. The first stage of wear is slower gear change at cruising speeds when approaching any type of incline. Second stage is the engine light will reveal a faulty oxygen sensor. Because the converter is basically a "filter" built into the exhaust system, it wears by slowly clogging, which leads to no starts, no power, and sometimes a blown head gasket. If your mechanic removed the oxygen sensor before the converter, theres a strong chance it would start right up.
SOURCE: 1988 nissan pickup engine rotates but does'nt start.
it sounds like the injectors are not opening up man.. replace the injectores and this should fix your problem..good luck keith....
SOURCE: 2002 Nissan Sentra Loses Power
SERVICE IT .....OIL PLUGS, AIR ,FUEL AND OIL FILTERS GET TROTTLE SENCOR AND THE MASS AIR FLOW SENCOR CHECKED
SOURCE: How to replace cabin air filter nissan sentra
lOOK BEHIND THE GLOVE COMPARTMENT. Compartmet is probabily plastic and all you have to do is push in real hard to get them past dash board.
272 views
Usually answered in minutes!
After the dealer replaced the computer/ecm I drove it and it stalled. took 20 minutes before it restarted. Then I got it to my place to sit. After a couple hours I drove it again and it stalled more then 7 times. The worst it has ever been and in half the distance. I hope the dealer did their job right when they programed the new computer/ecm. It took them about 20 minutes and that has me wondering why so fast.
×