Just changed oil but the change oil light is still flashing. How to reset the oil change light?
Turn the ignition key to on position, but do not start the vehicle.
Wait for the "change oil light" to come on
Tap the throttle pedal three times quickly
Wait for the light to flash several times, then go out.
Start the car and drive and it won't come back on.
It usually works the first time, but repeat if light stays on.
SOURCE: 2005 Chevrolet Silverado 2500HD 4x4 Oil Change Reset
Not positive 05 is the same but on my 02 you turn the key to the on position and pump the gas pedal 4 times.
SOURCE: how to reset oil light after oil change on 2005 trailblazer
Best of luck.
Greg
SOURCE: change oil light
Hi...
Are 2 step to RESET the engine oil on your chevy 02.
The first one ..
Turn the key to RUN position. Engine OFF.
Them FULLY PRESS and REALESE the ACCELERATOR PEDAL
For 3 times between 5 seconds and wait until the Change OIL start blinking and goes OFF.
Now the System is reset.
The second step is.
2-- This procedure need the RADIO, if you have an aftermarket
Radio you don't be able to do.
Turn the ignition switch to ON position,
turn OFF the RADIO,
Press and hold the Tune disp, button for 5 seconds or until
Settings is displayed,
Press the seek ptype or seek pscan up and dow to scroll the main menu,
Scroll until the OIL LIFE appear on display
Press the 1prev or 2next to scroll the sub menu, RESET will be displayed , Press the TUNE disp buttom to reset,
A chime will be heard to verify the new settings and done
Will be displayed for one second.
Press the TUNE DISP to exit from the program,
A chime will be heard to verify the exit.
I hope this help on your question.
Thank you for use fixya...
SOURCE: How do I reset the oil change light in a 2008 Chevy Suburban
Try this: turn the key to the RUN position (don't start it), press the
accelerator to the floor 3 times within 5 seconds. The oil life light
should flash twice, indicating that it's been reset.
If you have
steering wheel controls, you can navigate to where it says Oil Life and
then hold the arrow down, that should also reset the oil life.
SOURCE: Tried turning on ignition and pump gas pedal three times, but light still flashes
Look in you owners manual if you have one, It should tell you there.
If not call one of your local jiffy lube or minit lube, they should be able to tell you how to reset it.
Good luck
3,151 views
Usually answered in minutes!
×