The pads were wearever silver
SOURCE: Early wear on front brakes /rotors for 2008 Town and Country
I work for a brake repair shop and trust me you are not alone.Enterprise and alot of other people bought the same van and had the same trouble.I hate to say but it doesnt stop there.About every 14 to 15 thousand miles you have to replace the front pads.As of now they dont have an upgrade,for instance ceramic pads, but I am sure they will very soon
SOURCE: reconnecting caliper to rotor on 2005 pt cruiser
you need to open the caliper bleader valve and release the preasure out of the line. so that the brakes will retrat against the caliber. than you should be able to put them on the rotor. they might be a little snug but they will go on. than close the caliber. now you need to blead the brakes.
1a.Make sure that there is brake fluid in the resivoir.
1b.start the car and have it running until all the brakes have been blead up.
2.Go to the passengers rear and lossen the bleader valve.
3.have someone press the break until you see a steady flow of break fluid comeing out of the line.
4.once that has happend have them press the brake again and hold it to the floor.
5. tighten the bleader valve.
6.go to the drivers rear and follow steps 1-5 again
7.go to the passangers front follow steps 1-5 again
8. go to the driver side front and follow 1-5 again.
you might have to turn the wheel so the person can reach the bleader vavle up front.
Remember to check you fluid after every time you finish with a brake so you do not runn out of fluid and put more air into the lines..... also remeber to alway start with the brake farthest away from the resivoir. you always do them in order 1passanger rear2.drivers rear 3.passangers front. 4. drivers front.
if you need further assistance please let me know
SOURCE: I'm changing the rear brakes on my 2000 Chrysler
If the caliper is loose after taking off the caliper then all you gotta do is remove the caliper housing. The part the caliper is bolted to. It's usually two big 16 or 17 mm bolts.
SOURCE: front brakes wearing out on a 2000 town and
Possibly your rear brakes not engaging? To my understanding that would put the entire load on the front brakes and cause them to wear out prematurely.
SOURCE: Just changed pads calipers & rotors. now the
did you bleed the brakes when you changed the calipers if not you added air in the system and that is why you have no pedal
249 views
Usually answered in minutes!
×