Blend door acuator located
SOURCE: Cylinder location
Standing in front of your jeep and facing the engine. The number 1 cylinder is the one closest to you on your right (the drivers side of your jeep). The middle cylinder on the drivers side is the number 3 cylinder.
Driver Side Front to back is 1-3-5
Passenger side Front to Back is 2-4-6
SOURCE: how to replace rear brake pads on 2005 jeep liberty
put the back of car on jack stands and secure the front tires so it does not roll and then remove the bolts off the back of the caliper there is normally two one at top and one at bottom and spray it with some kind of oil for rust and make sure you have the right size socket before you try to loosen them and once caliper is off and the old pads removed take one of the old pads and squeeze the piston on the caliper back in by using a "C" clamp and also remove some of the brake fluid from the master cylinder before you do this put the new ones back on and check the brake fluid and make sure it is full and then pump the brakes to make sure you have a good pedal also put some "No Squeak" brake stop on the back of the pads so they don't squeak they will have that where you buy the pads from
SOURCE: power locks on 04 jeep liberty not working
Most of the times on jeeps and all chrysler auto's they have a body control modual this is what controls your door locks , windows ect. It should be in the owners manual for all fuse location and identification. A shop with a scanner can check the door lock system for you. body control moduals go bad alot on all chyslers and if you buy one you need to buy it from the dealership they will program it . So check the owners manual for a fuse and then have the body control mod checked
SOURCE: rear gate won't open
it is because the hydraulic of the rear door is not working properly.. must be hydraulic pressure lost in the rear door.. plz do rate me...
1,076 views
Usually answered in minutes!
×