1996 honda passport defrost has stopped working

How to drill open a honda door that's stuck or won't open (no ...

? 0:19
www.youtube.com/watch?v=xHX6Up7HCfs
Jul 2, 2006 - Uploaded by SadieSummer How to drill open a honda door that's stuck or won't open (no real info on .... How To Install Replace Broken Rear Outside DoorHandle 1996-00 ...

How To Install Replace Fix Broken Rear Outside Door ...

? 9:52
https://www.youtube.com/watch?v=bUV6BZfVxDY
Jun 15, 2011 - Uploaded by 1A Auto Parts
How to Open a Honda Door that's STUCK! ... How To Install Replace Broken Rear Outside Door Handle 1996-00 Honda Civic - Duration: 5:47.

Honda Passport driver door lock stuck Questions & Answers ...

www.fixya.com > ... > driver door lock stuck > Cars & Trucks > Honda
Honda Passport cars & trucks driver door lock stuck questions and answers. Ask your ... 1996 honda passport defrost has stopped working ... dash vent ... Back seat doorsdo not open ... stuck. Any ideas of how to get them to open? It seems that ...

ur r going to have to check the button or the release lever that alouds u to move the air to the other positions sometimes that's the problem

I assume your heater setting is electric control, if so either your defrost and floor heat switch failed or wire problem. For the air not hot, check the heat control valve on the top of the hose it should be in front of the firewall. I don't know your car is using mechanic valve or electric control valve. Anyway check there first. Good luck.

light bulbs, and or fuse

it's the relay behind the kick panel. Drivers side near the floorboard. To the left of your left foot there is a plastic cover, pop that off and there will be 3 or 4 relay fuses there. Swap em out with eachother until you figure out which one it is. When you go to purchase another one, get the fuel pump relay (they're the same) and it's ALOT cheaper! lol

the directional for defrost and dash panel may have gone bad,there is no fuse for this. under the dash on the main vent,you will see a little box/with an electrical plug in. it's called an acuator.when you turn the knob to defrost,or dash,the acuator turns the door on the main vent to let the air flow to either the defrost,or dash.your acuator is most likely your problem.there is only one plug in to it and only 2-3 screws that remove it frome the vent panel under the dash.thank you for choosing fixya.com!

Hope I was avle to help, glad you up and going.

I already posted my solution.

disconnected or cracked vent tubes

Fan motors are vulnerable to junk falling into vents, fluff and debris being sucked in with air, as well as mice dragging nesting material in and setting up house inside squirrel cage. THis happens alot. Also, fans usually have a clip of some sort that has been added at one spot around the edge to balance the wheel during rotation. If this clip falls off, or an object causes a crack, or debris falls into the fan housing, the resulting imbalance will make noise! Fans are also easy to remove and check for trash or damage. Remove the fan motor and inspect for these or any other faults. COuld be a worn shaft bearing that's causing the vibration or rumble. Should be able to lay fan in floorboard, plug in and turn on. Hold the edge of the fan to stabilize it, and observe its operation out of the housing if no defects are found visually. Hope this helps you. TT