Handbrake adjustment i'm looking for the handbrake adjustment on a 2002 v70 volvo. many thanks.

The first thing you must do is have the computer control module for the engine scanned for fault codes.

check your front tires for separations

clean the switch with cumputer air

Thats the ait idle controll solinoid faulty nhave it changed.

Hedadlight removel Volvo V70 2002

Yes the full front bumper has to be removed. Not as bad as it sounds just take your time. One fixing screw in each wheel arch, two bolts behind black bumper trim each side of no. plate, and five or six plastic
plugs on slam panel. Remember to unplug fog lights if fitted. The lamp unit can then be removed secured by thee bolts two on slam panel and one on the inner side of the lamp near the radiator and a clip on the outer side, obvious when you take a good look and dont try to rush.
I hope this will help anyone else.

Hi there,

Well i have a link to help you the link is with all necessary pictures so you can understand easily -

http://www.matthewsvolvosite.com/handbrake_cable_replace.php

note. it is for Volvo V70 AWD but it is same as to your model.

Good Luck!!

Thanks

not the pump its the flexible line from metal pipe to the sender unit ,these pipe dont last like they used too and if you look you will see where the pipes have gone porous ,check under bonnet as well on the other ends

gearchange movement worn lift cover on gearsick and look below to see whats loose

must be the after market rotors not a normal problem and do not adjust park brakes to tight at all ,some rubbing noise is normal

pass side floor remove the panel at bottom the take out all floor mats remove 4 screws at bottum (stand on your Head helps) pull out filter and look at the way it came out ,use only oem or it will be a job