The door trim panel can not be lifted up to get it off the top hooks because it is restricted by the inner door handle that extends through a hole in the trim panel. Is something else stopping it from betng lifted? How door I get the trim panel off to get at the electric window switch?
I tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. it wont move forward or reverse, engine is good both solenoids for forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.com
SOURCE: remove right rear door panel
INSTALLATION PROCEDURE
IMPORTANT: Discard the old door trim panel retainers and replace with new retainers before installing the trim panel
SOURCE: 2000 oldsmobile alero gl 2.4
The window regulator is what causes the plastic clip to break. I had the same problem. I was able to find a new clip at advanve auto parts, and had to purchase a regulator which includes the motor from ebay. There were many diffrent options out there. Total cost was about $60.
SOURCE: Ignition switch
To install:
SOURCE: how remove the rear inside door panel on a 2001 oldmobile aurora
The inner door panel is held in by clips and screw.
Look at the door near the door handle there should be screws holding it in and along the outer edge of the door. Once loose, and the door handle removed or the arm rest removed. The door panel then prys out , because of the clips that hold it on. Then pops out by applying pressure to the panel upward to the top of the door. The clips always break because of the design and plastic.
Good luck
SOURCE: remove driver's door panel
Start prying the door panel off with a flat head screw driver. It's held on by plastic clips, and a few screws. just pry it back and look in there with a flash light, you'll see. Just pry them out. If your lucky you'll only break a few. No real easy way to remove those.
198 views
Usually answered in minutes!
×