When I put it in forward or reverse and press the gas petal nothing happens for 5 or 10 seconds than it will engage
SOURCE: Electric Golf cart only shutters and inches forward
so many possibilities...
does it roll fairly freely? (checking to see if the brakes or rearend seized up)
Are there any "bad" sounds like things grinding? (Connection between Motor and rearend, axle splines...)
If all that is solid, it is likely in the controller.... (it takes a solid charge right... No bad batteries in there or loose connection? might want to check all the battery connections to make sure none are burnt...)
1997.. does it have the electonic speed control by that year? the other possibilty is that the accelerator is not working corectly. they used a resistor system on old ones that has contactors that would get worn out.... Newer ones control a potentiometer(sp) that controlled the speed.
Only a few real components to check, but if you are not mechanically and electically inclined, could be tough to isolate.
peace,
SOURCE: Mazda 626 auto tranny engages slow switching from reverse
Sounds like a pump issue, check line pressure. If it does have a bad trans pump it can be changed with out removing the trans. But also check the fluid level if you haven't already.
SOURCE: jerky accelerating, late response to gas being pressed
Well for one, make sure you speed up slowly, dont HIT the accelerator. It may also be problems with your fuel filter. After you are stoped fuel stops running through the fuel pump/filter and then when you start going its starts to run through again and it cant keep up so it gets bubbles in it and doesnt move throught the filter easily hence the jerky accelerating. Good Luck
SOURCE: car will not drive in reverse, does not pick up speed when driving forward
TRY REPLACING THE TRANSMISSION FILTER LOCATED INSIDE THE TRANS. THE TRANS PAN MUST BE REMOVED TO ACCESS THE FILTER. A GALLON OF FLUID WILL NEED TO BE REPLACED AS WELL AFTER FILTER HAS BEEN DONE. THIS PROCEDURE WILL HELP THE OIL PUMP IN THE TRANS TO GET MORE FLUID AND HELP IT TO SHIFT GEARS. HOPE THIS HELPS. PLEASE KEEP ME POSTED. THANKS FOR USING FIX-YA AND FOR AN HONEST RATING TOO. BEST OF LUCK.
SOURCE: 1999 ezgo golf cart.need to know the whole wireing
When you removed the batteries, a certain procedure MUST be followed. Key switch off, switch to tow position and shift lever in reverse. You must wait until the beeper unit sound dies out then remove the wire from the most NEGATIVE cable. Place in Neutral before installing new batteries. There is a specific sequence to putting the batteries in an EZ-GO cart. Failure to follow this procedure will kill the controller. The Key switch must be off and the maintenance/tow switch MUST be in the tow position when connecting the batteries. Any of the above will cause the controller to fail, due to improper discharge of the PRE-Charge capacitors.
You may have this
posted in the wrong product category. Please select another category
appropriate to the problem and re-post the problem so the correct
expert will see and respond to the question..
This is for
car and truck problems.
725 views
Usually answered in minutes!
×