2000 ford crn vic want go into drive, but have reverse. Check fluid (full) fluid dosen't smell burnt. never slipped or acted up.
Check pressures for drive gears if not in range then possable bad clutches in the ****** if you have a scan tool scan for shift coads and tern your shift sylinoids on and off to see if you have engagement if not rebuild or replace
SOURCE: i need a diagram for a 1998 ford crown vic interior fuse box
ITS FUSE #16 AND ITS a 20A FUSE
SOURCE: 1995 crown vic gear problems/gear shift wont lock
most likely the shift tube bushings are bad- you may have also lost a few screws in the shift tube or they could just be loose. you have to pull the steernig column down to inspect/repair it.
SOURCE: Where is the fuse panel on a 1985 Ford Crown Vic located?
Local Ford dealership service department provide answer on location of the fuse panel. Fuse panel is located directly under the steering column. The cover panel is held by two screws and the power antenna swithch locking ring must be removed.
thank you all for you assistance,
SOURCE: no drive gears
why should i tell you how i fixed it if your going to charge me 30 bucks to get an answer from you?
pay me 30 dollars for my solution!!!!!
SOURCE: HOw to disable drl on 2010 ford crown vic?
check your owners manual for location of relay take out relay
545 views
Usually answered in minutes!
×