My Mercedes will only go in reverse and wont go forward what can be the problem?
SOURCE: method of charging a 2004 Mercedes E320 battery
It is always safer to charge the battery out of circuit, Removal of one cable will insure you can safely charge without hurting electronics on board. Generally if your battery is already sufficiently charged it acts like a capacitor in the circuit and will prevent damage, but many battery chargers do not always put out a pure dc voltage and this can damage electonics.
SOURCE: 99 mercedes e320.check engine light on.po341
that appears to be a camshaft position sensor performance code. you can start by checking to see if the sensor is working properly, re-check and make sure that the harness is ok by checking the resistance through the harness if all looks well there make sure the computer has the latest software on it by having it scanned at your local dealer. also you can check the reluctor wheel on the camshaft for damage or debris in the way of the sensor.
hope this helps!
SOURCE: e320 reset SRS
Hi,
Joe here to help,
Without going to a dealer, you need to get a scan tool to reset the srs light. Go to an Autozone store, They will scan it and reset it free of charge.
SOURCE: how to replace a water pump on mercedes e320 1997
It is not complicated, depending on what hands-on level of DIY on car. Here are what need to do, so you can estimate how easy or hard when you look through your engine. Drain all the coolant, remove the thermostat housing, remove the fan, belt. Remove the water pump pulley. There are 4 bolts to hold the water pump in place.If you think you can take them out and put them in without removing the AC compressor then you can do it. I did it twice without removing the AC. The pump was fine for the second time, but for leaking seal. At dealer, it is easier to access from the bottom since they have a lifter. But it is doable at home. Have fun if you decide to do it.
63 views
Usually answered in minutes!
×