SOURCE: Ignition will not turn
we had the same issue with ours a few weeks back, i was prepared to remove the key assembly. i started disassembling the steering column and removed all the trim, and while removing all the trim and the lighted key ring from the switch, i noticed a small pin on the side of the keysitch housing, if you put your key inot the switch and try to turn it, this pin moves in and out as the key is turned, ours wouldnt budge, or was stuck. i pressed it a few times with a small screwdriver, and sprayed it with some trusty wd40, and walla. it now works fine. would probably tak you about half hour to fix if you wanted to try what i did, if not then you may need to call a locksmith. i hope this helps, although you may have a different problem than we did.
SOURCE: 2001 Town & Country ignition switch locked
you need to call a locksmith to come to your home. They will replace one or more of the tumblers/cylinders inside the ignition key area. The EXACT same thing happened to me. The Chrysler dealership wanted to charge me over $400 to fix the problem. My wonderful mobile locksmith knew exactly what was srong the nanosecond I mentions the make and model! $49.00 later - FIXED! good luck!
SOURCE: On Chrysler Town and Country van keys were locked in the car and
does this van have factory theft device? if so you may have to reset to get the ramp working
SOURCE: Flickering dash lights and erratic guages in 2005 town & country
We have a 97 T&C AWD... same thing happened to us. We had to bought a new Body Control Module... that didn't fix it. We ended up buying a new insturment cluster. Hope that helps some.
118 views
Usually answered in minutes!
×