Put key in ignition and it will not turn.
SOURCE: how to replace the ignition key in my 2005 bmw 645ci
this can be very difficult to do you must make sure the baterry for the vehicle is disconnected you must remove the casing around the location of the ignition key barrel and there should be a few little pins holding the cylinder in itself with a plug attached be advised though some vehicles with electronic keys may crank over but not run without reprogramming the computer because the car may read the new key set up as someone trying to steal the car just make sure the battery is unhooked this is very important
SOURCE: I have a 1998 BMW 528i, and the ignition is messed
A ignition is in two parts, where you put the key to turn it and a second part that is the ignition itself. Between the two parts there is a small flat pin or bar. This is where your problem is, the pin/bar is broken. You will have to replace the ignition to solve the problem.
SOURCE: i cant get the gas tank on my bmw 528i to open
you have to stick the key in the trunk and unlock the trunk to get the gas door open!
SOURCE: 1998 bmw 528i battery died how to open trunk
You can jump your 98 528i from under your hood. On top of the center of your engine there is a positive (+) sign. You have to pry the cover open and there is also a negative ground spot to the left of that. Bmw is pretty smart!
SOURCE: 1997 bmw 318i key spinning in ignition. car doesnt
Sound like the key barrel is broken, remove the swith from the back of the ignigtion and check the barrel.
461 views
Usually answered in minutes!
×