Has a little bit of grinding when shifting in and out of park
Sounds like you blew the rear end have someone run it in 2wd while you watch the rear drive shaft if it spins and the truck doesn't move the rear end is blown
SOURCE: 1997 GMC Jimmy 4x4 SLE
You may have a combination problem. Your system uses electrical/vacumn. The ducts are operated by vacumn being directed to different hoses by the electrical switch. If you can get to one of the hose with the engine running, pull one off of its ports and check for vacumn.
Bill
SOURCE: MY 1999 GMC JIMMY SQUEAKS
you may have bad struts and double check the serpintine belt it might have bad pulley or belt is bad!!
SOURCE: Front end 95 jimmy
Sorry not sure what kinda noise your hearing but here are a few things that would cause that.
1 Check for worn ball joints.
2 Check for tire pressure.
3 Check for wheel bearing failure.
4 Check for worn brake pads and rotors.
5 Easies on is to check to see if the brake dust is rubbling.
Good luck and hope this helps
SOURCE: i have 1997 gmc jimmy sl5 it will not shift out of 4 hi
I believe that this vehicle has a vacuum controlled solenoid on th edrivers side of the transfer case. This solenoid could have lost vacuum by having a broken vacuum hose or the solenoid itself is bad. To test remove the vacuum line and see if the line has vacuum going to it when running. If so replace the solenoid. If the vehicle has a electronic dash control to engage the 4 wheel drive the switch has been known to go bad. The best way to test is to see if there is voltage at the switch and to see if the voltage changes when the switch is activated. If there is no change in voltage when activated the switch is bad.
SOURCE: 1997 Chevy Lumina won't shift past 2nd
Have transmission service, oil and filtr. .Anywhere but aamco. sounds like valve body os sticking. do it soon.
81 views
Usually answered in minutes!
×