SOURCE: SPARK PLUG INSTALLATION ON 2006 DODGE CHARGER 2.7L
In my experience with the 2.7L engine, the spark plugs are located on the top of the engine below the individual ignition coils. The coils are placed between the intake manifold and the valve covers, 3 per side. The coils are held in with "torx" screws. Simply remove the screws, and disconnect the connectors to remove the coils. The spark plugs will be underneath. Be sure to properly gap the spark plugs for maximum life and emissions compliance. Also, an improperly gapped plug can shorten the life of the coil packs.
Hope this helps!
SOURCE: 2006 dodge charger pcv valve
5.7L
The PCV valve (3) is mounted into the top/right side of the intake
manifold (2).
1.The PCV valve (1) is sealed to the intake manifold with two
O-rings (2).
2.Remove PCV valve by rotating counter-clockwise 90 degrees
until locating tabs (3) have been freed. After tabs have cleared, pull valve
straight up from intake manifold.3.After valve is removed, check condition of
two valve O-rings (2).
__________________
3,277 views
Usually answered in minutes!
×