I'm trying to locate the ac compressor relay. I have a correct charge and the fans come on when the ac button is pressed.
SOURCE: 1991 Sierra GMC AC control problem
The follwing is a cut and paste from a service bulletin:
Bulletin No.: 461202
Date: May, 1994
SUBJECT:
A/C CONTROL HEAD FLASHES OR ERRATIC OPERATION OF A/C CONTROLS (POLISH
TERMINALS)
MODELS:
1988-94 CHEVROLET AND GMC TRUCK C/K MODELS
1990-94 CHEVROLET AND GMC TRUCK TOPKICK/KODIAK MODELS WITH C60 OR C69 AIR
CONDITIONING
CONDITION:
A/C Control Head flashes, performs erratically or malfunctions.
CAUSE:
Light surface corrosion on the Control Head terminals.
CORRECTION:
Remove the A/C Control Head and while holding the unit with the terminal
cavity down (toward the floor) so no particles will fall inside on the
circuit boards, polish the terminals on both sides of the cavity with a lead
pencil pink eraser. Do not use an ink eraser or other abrasive such as a
small wire brush or sandpaper, etc. Doing so will remove the terminal
coating and degrade the contact surface.
Performing this procedure, in many cases, will make replacing the Control
Head unnecessary. Using this procedure in conjunction with the A/C circuit
diagnosis found in the Electrical Diagnosis Manual and especially before
replacing a Control Head for any reason is recommended.
After polishing the Control Head terminals, but before reconnecting, check
for proper terminal contact as described in the applicable electrical
diagnosis manual. If contact is good, apply dielectric grease (P/N 12345579)
to the harness connector terminals. Please do not apply grease to the
Control Head.
SOURCE: location of starter relay on a1992 honda prelude
the starter solenoid is attached to the starter
SOURCE: 1989 honda prelude. engine surges. from normal to 2100 rpms
There is a warm up valve on the throttle body(should have 2 small coolant hoses). remove the valve and have someone start the car while you block the port to the valve on the intake. If that clears up the problem you can cut a piece of cardboard to mount in between the valve and intake.should straighten it out.
SOURCE: ac compressor clutch relay 1991 honda accord
Difficult to describe, but I will give it a try.
Inside the driver's side fender, close to the front of the car, there is a bracket that is held in place by one bolt, but which has a short horizontal bar as part of it which has two large clips encircling two cylinderical devices which have wires clipped into them at the bottoms. The one closest to the front (radiator) is the compressor clutch relay. The other one is the condenser fan relay.
Hope this helps you find it.
SOURCE: jump air compressor ac works replace relays same issue HONDA
the compressor may be low on freopn but, the fan problem is most likely the fan motor as it is the low temp fan and will run more often than both fans...to test see if you can switch the fan plugin to the other fan watch carefully that it does not get too hot as the second fan is a safety fan that works as high temp or when using the A\C
647 views
Usually answered in minutes!
×