At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Aside from the obvious checking the oil level, Some vehicles have an oil sender that plugs in near the filter. Check for any sensors in the area and make sure they are connected properly.
When you open the drivers door there is a fuse box on the dash where it meets the door. Pull off the cover and there will be a red reset button. Turn the car on but do not start it. Once the power is on tap the reset button until the chane oil light is flashing, the hold it down until it goes off. This is how you also reset the check tire pressure light.
turn the key on step on the gas pedal to the floor 3 times within 10 seconds then the C.O.L. should blink 5 times turn key off then start normally make sure the door is shut or it may not reset
I believe it's 4 quarts, but I always get 5 as an extra -- add 4 then start the car and let it run for a few seconds (~30 or so) then check level (while the car is level) and add as necessary -- a gauge of how much to add the amount between the low and high lines on the dipstick is 1qt - so if it's right at the low line, 1qt will put it at the high -- ideally, it should be in between the line.
Just to confirm that the oil Fill plug to a Daewoo lano manual tansaxle is on the right hand side of the transaxle where the drive-shaft exits the gearbox housing.
turn key to on position
(DO NOT START) press and release gas pedal 3 times.
leave key on the change engine oil light flashes 5 times than goes away and its reset
The place that changed your oil should have done this for you
×