My escape door ajar light is on and we got code po113 please help and rough cost to fix it
Two different problems.
PO113 is a code for the intake air temp sensor.
The sensor could be bad or could be another problem.
The normal test is to take a scanner and "read" the air temp coming from the sensor. It should be around same as the outside air temp.
SOURCE: 2005 Ford Escape - Door Open Indication Light & Horn Alarm Sounds
This is probably caused by:
a loose door switch, or
a loose connection to a door switch, or
a defective (dirty / corroded) door switch.
There is a false signal being sent that a door is open / ajar.
SOURCE: where are the door pins for the door ajar light
The door ajar switches are located inside the door they are attached to the door latch assembly, they twist in, you will need to remove the rear window glass run channel to access them, this is your problem, the switches stick and cause this problem. There is a TSB concerning this problem as well.
SOURCE: Door Ajar light wont go off.
replace the relay for the courtesy lights. the relay should be under the dash in the fuse panel on the drivers side. if you can't figure out which one. just put your finger on each one till you find the hottest one by touch.
SOURCE: 95 ford windstar door ajar
These switches are inside the doors attached to the door latch assembles.If you know some one with a scan tool you can go into the body computer and see which one is showing open when all the doors are closed. The most likly one is the drivers side door or the two in the rear gate. I've replaced those the most.If you don't want to replace them you can unplug them and the lights will go off. Hope this helps. If you need more info let me know> Thanks Dan
Take some WD40 and open the doors and spray a liberal amount into each of the door latches. Then open and close the doors firmly several times. This will work most of the time to unstick the ajar switches.
1,393 views
Usually answered in minutes!
Thanks everyone we will check it out!
×