Dve navigation problem bmw 1 series

https://www.youtube.com/watch?v=r4UDs4ukO-Q

Please refer to my previous link

i need gps navigation cd for my bmw 318 i 2004

This SIB may apply to this issue:

SI B 65 24 07
Audio, Navigation, Monitors, Alarms, SRS August 2007
Technical Service

SUBJECT
CCC Navigation Map DVD not Detected


MODEL
E90, E91, E92, E93 (3 Series) with SA 609 (CCC Navigation)

E60, E61 (5 Series) with SA 609 (CCC Navigation)

E63, E64 (6 Series)

E70 (X5) with SA 609 (CCC Navigation)

Vehicles produced from 8/31/2006


SITUATION
When entering into the navigation system, the screen only displays "Please insert DVD", even though a DVD map is inserted in the drive.

CAUSE

Incorrect map DVD

CCC software or hardware error

PROCEDURE
On a customer complaint basis proceed as follows:

Always verify that the correct map DVD is used (identified by DVD-CCC). Try a known good map DVD and see if the problem is resolved.

Update the complete vehicle per SI B09 05 01 (Programming and Coding with Progman) Procedure B, using Progman 25.00.00 or higher.

If the fault is still present, replace the DVD drive. Refer to Repair Instructions RA 65 83 580

PARTS INFORMATION
Part Number
Description
Quantity

Refer to EPC
DVD drive
1

WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle Limited Warranty.

Please refer to the latest KSD for all applicable labor operations and allowances.

If the appropriate labor operation is not contained in KSD, then a work time labor operation should be used.

Go to hidden menu and check if the gauge works correctly

This happened to my 06 325i, the navigation and instrument cluster displays are not controlled by the same computer, mine had to go back to the dealer for a reprogramming, hope this helps. let me know.

you neeed to replace the navigation unit.I had that same prob on one of those cars. replace the nav unit and not bright as day

Find and read your warranty,it will answer your question.Is the dealer responsible?

hi there

there are three things that would cause this problem

1. the window motor is bad
2. the fuse that controls the window is blown

3. most common is the window switch its self

this is the most common cause
if the motor was going out it would make a noise or go down very slow but going down is easier then up so thats what makes me think switch or fuse

don

if you have a volt meter, check the voltage at the battery before you start the engine and after the engine is running, before could be 11.5v after should be 13.5 or higher but no higher than 14.5, this will test the altenator, check the belt by pressing on the middle of the belt between the two pulleys the belt deflection should not be more than 1/2", if it is tighten and retest altenator