The Electronic throttle control light is on. Car will crank but won't start anymore. No check engine light is on. 2007 Chrysler Sebring 2.4L

SOURCE: The car cranks but won't start

The crank sensor or Timing belt are two common problems with this car that can cause this. Goodluck

SOURCE: 2001 CHRYSLER SEBRING, THE STARTER IS CRANKING THE

what size engine this vehicle has? if it is a 2.4 inspect timing belt, also you may remove spark plug and inspect air pressure coming out of cylinder while cranking engine

Testimonial: "THANKS."

SOURCE: I was going to start

Hello, The first thing we need to is see what fault codes are setting. With the doors closed cycle the key from off to on three times ending with it on and watch the digital odometer display. Don't crank the engine, just off to on. The codes start with a P and have four numbers, there may be more than one stored. Write down any that you see and post them here.
Here is a short video of the procedure to retrive codes.


http://www.youtube.com/watch?v=1D3Tjc-EL-o

SOURCE: rough idle and check engine light concord

Check your EGR valve and your IAC Idle Air Control valve make sure both are functioning correctly

SOURCE: The car cranks but won't start

Ok, check the following below--

1. Check the Ignition control Module for its operational value. it may be damaged.

2. Check the coils.
3. Check the plugs and wires.
4. Check the ECM/PCM/ECU(All represent the same device that is commonly known as the engine control computer)

Check these areas thoroughly for faults. I would also advise to replace the fuel filter and fuel pump as well.