2011 holden barina workshop manual

SOURCE: holden barina 2003

it means its due for service. If u wanna get rid of it without servicing the vehicle then as you start the car simultaneously push the ODOMETER reset button on the dash and it will wipe it. This will however just delay the point your car needs servicing.

SOURCE: changing a fuel pump on a 1991 holden barina

The Fuel Pump is Inside the Fuel Tank. You will need to Trop the Fuel tank for this. Not an Easy Job by any Means.

SOURCE: holden barina 1994 manual gearbox linkage problem

had the same sorta problem with my one, i replaced the las part of the linkages thats connecte to the gearbox, that helped with it. also check to see if the blots holding ur gear stick in place are tight

SOURCE: holden barina 94 model speedmeter not working how

There should be a cable that runs from the back of your speedometer to the transmission. If you look on the engines side of the firewall you should be able to track it....it is one of very few cables that run into the transmission. NOTE: its a little thicker than most. At the transmission there will be a fastener of some sort holding it in. Unscrew it and check the end of the cable. If all seems well try attaching a drill to that end and have a buddy look at the gage to see if it shows speed when the drill is running ...if not then its either broken in the middle somewhere or came unhooked from behind the guage....if it does show speed then it was either not seated correctly to the transmission or the plastic tip (looks like plastic gear) on the transmission side of the cable it worn down too far. That tip is interchangeable for if you get bigger/smaller tires.

SOURCE: I need a free workshop manual for 1.3l 1991 holden

http://www.teamswift.net/viewtopic.php?t=26290

This might be what you are looking for It is on an MK1 But i think it is the same for a Barina

If not search the site for lots of good info.