I need a 1998 Dodge Grand Caravan serpentine belt diagram.

Tensioner badly adjusted or pulleys are misaligned.

Take it back to the shop and ask them to fix the tension under the repair warranty.

There should be enough tension that the belt can't jump the pulleys. There is a small chance is is misrouted.

https://www.2carpros.com/diagrams/dodge/grand-caravan/1994

https://www.google.com/search?q=94+dodge+grand+caravan+serpentine+belt+diagram

..

Altenator down to the idler pulley and than power steering and down to A/C and hermonic balancer and than up to the tensioner and up tothe altenator

i need to see a diagram for a 2010 dodge grand caravan with a 3.3 liter It has air condtion

Fig. Fig. 11: Accessory drive belt adjustment-3.3L and 3.8L engines
All of the belt driven accessories on the 3.3L and 3.8L engines are driven by a single serpentine belt. The belt tension is maintained by am automatic tensioner.

1. Disconnect the negative battery cable.
2. Raise the front of the vehicle and safely support it with jackstands.
3. Remove the right front splash shield.
4. Release tension by rotating the tensioner clockwise.
5. Remove the belt and install a replacement.
6. Proper belt tension is maintain by the dynamic tension.
7. Install the right front splash shield. Lower the front of the vehicle.
8. Connect the negative battery cable

if you buy your belt from Autozone the belt routing is on the box

If it's the diagram you're looking for, click on the link below and enter your engine size. You will be directed to a page that has a Belt Routing Diagram. Select the appropriate one (some Caravans do not have AC) and you will receive the diagram for your vehicle.

1998 Dodge Caravan Serpentine Belt Diagram

How's this.

On this particular model of the 1998 Dodge Grand Caravan I determined that the upper hose from the water pump had slipped off and anti-freeze squirted on the serpentine belt causing it to slip off. Once the belt gets slick it never stays on. I replaced the belt by loosing the tensioner which is the idler pulley located in the center of the configuration, A big thanks to user motor1258for the configuration diagram.

What engine do you have? The 3.3 and 3.8 engines have a single serpentine belt, and a belt tensioner, so no adjustment is needed. Did you replace the tensioner, and want to know how much to torque it? countrycurt0

The belt routing diagram is located on the top radiator cross member by the hood latch. You should see it when you open the hood. If it is not there, all Chrysler, Dodge, and Plymouth minivans, from 1993 to at least 1999, used the same 3.3L engine setup, so find someone with one and look for the diagram where I described.