Cars & Trucks Logo
A
Anonymous Posted on Jun 19, 2012

Abs, esp, brake and traction light on

Started my car backed out put in drive then my ABS, ESP, Brake and traction lights came on. Stayed on stopped my car, pulled up my emergency brake put it back down turned off my car started my car again drove and again the lights came back on. So is the deal?

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Nov 13, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Nov 13, 2012
Answers
1
Questions
0
Helped
3945
Points
1

Oh I have exactly the same problem right now!! Machanics are saying the back LH speed sensor is faulty however when they checked the computer there were no error codes. The braking issue has stopped but warning lights have been on constantly for three weeks now :( Its due to go back to the machanic in a few days so they can have another look.... What ended up being the problem with yours?

5 Related Answers

Anonymous

  • 6 Answers
  • Posted on Apr 11, 2009

SOURCE: speedometer intermittent and ABS/Brake light stays on

Vehicle speed sensor located on top of the rear diff at the brake line clamp a single bolt with a wiring harness. replacement from NAPA comes with a new extension harness. use grease on the terminals before assembly.

Ad

treylee77

  • 2 Answers
  • Posted on Aug 22, 2009

SOURCE: 2001 dodge ram 2500 abs light stays on and soo doe

I had the same problem and it turned out to be one of the front speed sensors and the rear speed sensor as well. If you get a chance to look at all the speed sensors make sure the wires on the front aren't burnt from hot brakes. I have an 01 3500 4X4 and it was a pain to change the front sensor but the rear sensor took about 5-10 minutes, it's located in the middle of of the rear axle right on top. I bought both of mine on Ebay and cut the price in half.

Anonymous

  • 202 Answers
  • Posted on May 27, 2009

SOURCE: emergency brake light comes on while driving

The wire that connects to emergency brake is loose, and grounding out. It probably just needs to be tightened up.

john h

  • 29494 Answers
  • Posted on Oct 27, 2009

SOURCE: 2000 Dodge Durango 4.7 ABS, BRAKE, ENGINE light on

check fuses and relay for ur abs- possible bad relay or abs unit -have vehicle scanned some auto stores such as auto zone /advanced auto do scan for free ur trouble code(s)will give u a place to start

Anonymous

  • 1 Answer
  • Posted on Sep 26, 2010

SOURCE: abs and park brake light came on same time

Its either the speed sensor on the rear differential or your steering wheel is all the way down pinching a wire in the harness. I have had both problems. Raise the steering wheel and if that does not fix it then its the speed sensor(might be called something else) but it is on the rear diff.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
2answers

Traction control light is coming on going around bend at only 50 mph

VWVortex.com - Traction control light flashing, losing power?

forums.vwvortex.com > ... > VW Model-Specific Forums > Golf IV R32

May 20, 2011 - 25 posts - ‎14 authors
So last night I was driving home, went around a pretty sharp turn and my traction control light started flashing for about 5 seconds, then went ... Traction control and ABS light issues
15 posts
Feb 22, 2010
E-Brake warning light stays on -- help
22 posts
Sep 27, 2004
More results from forums.vwvortex.com

Abs and Esp Lights on!? - TDIClub Forums

https://forums.tdiclub.com/showthread.php?t=333091
Oct 18, 2011 - VW MKV-A5 Golf/Jettas. ... Suddenly i noticed that the ABS and the ESP light on the dashboard was on. ... Fuel Economy: 47+ Avg (Passat DSG) 50 Avg (SE Manual) Warm Weather. ... I might suggest that your ABS and traction controlpick up their information ... A bent ring or bad sensor will set both errors. On-and off grinding on hard left and traction control light ...
Nov 3, 2015
ABS brakes activating when slowing down - wheel speed indications ...
Jan 20, 2012
More results from forums.tdiclub.com

Electronic Stability Control - Auto Diagnosis Repair Help


0helpful
1answer
0helpful
1answer

I have a 2000 Mercedes E430 base sedan. Last week I replaced the brake light switch because it was out and it solved the problem to the point that I can now put my car into gear and drive it, however, as...

Brake light switch problem may cause the ESP / BAS lights to illuminate.

Common symptoms of a bad
Mercedes brake light switch.
  • Car stuck in Park.
  • ABS ESP ETS lights come on.
  • Can not move the shifter from Park to Drive.
  • Brakes Defective Warning on Instrument Cluster
  • Car won't shift gears. Stuck in 2nd gear, limp mode.
  • Brake lights don't work. (Brake light switch can still be defective even if the brake lights work. Checking the brake light operation is not a good test.)
  • ESP, BAS, ABS lights turn on. Car won't shift properly. Stuck in gear.


TEST: To test your new brake light switch: Turn you car off to reset the ABS light. apply the parking brake. and start the car in neutral or park without using the brake. if the problem is the brake light switch... the light will only come on when you press the brake pedal.

If you replaced the brake light switch and the light is still on you should check a few other things such as:

  • Fuses and Relays
  • ABS pump
  • ABS wheel speed sensor
  • Brake Fluid Level
  • Get an advanced scanner to read trouble codes.


NOTE: ** You may need a MBZ scan tool to reset the error code which was stored in the ECU because of the bad brake light switch.
0helpful
1answer

Abs, esp, brake and traction light on

Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it to me and I thank him even today
They have full manuals and it's verrrrry cheap and mine
I got free in offers
3rd time I bought it, I also had an issue with the file so the girl replaced it in 30 mins
there is one website more but i don't remember its name it was 2 years back bitman something link this
Try these out brother
5helpful
2answers

2008 wrangler. abs, esp and traction control light staying on. checked brake fluid and fuses

Check first the third eye brake light. does it work? okay the problem reside in a ABS sensor make sure it is hook up or if you recently did a brake job it didnt get contaminated. When the ABS signal is interfered with ESP,Traction is disabled. One or some of the wheel speed sensor is disconnected or is being interfered with. This is common for a recent brake job if any occured
1helpful
1answer

ESP light and brake light are on. What does ESP mean?

Traction control / ABS fault

ESP = Electronic Stability Programme
0helpful
1answer

Car shakes after stat up

check the battery ,check and replace wheel bearings,check replace wires and fuses.
Not finding what you are looking for?

3,955 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...