Diagnostic code p0335 - 2005 Dodge Grand Caravan

Need a bit more info about that. You need to get hold of an OBD2 diagnostic tool (code reader) , plug it in and read off DTC's (Diagnostic Trouble Codes)
heres a link to saab.se trouble codes listing, look up the Code numbers and make a note of the codes that your car's ECM throws up.
https://saabinfo.se/en/og-9-5/error-codes/obd2-error-codes/

usual suspects are CPS (crankshaft position sensor), which are in the general area of P0335 onwards in the listing, but it could be a number of other things too. More info required please.

A dtc does not say to relace a part untill diagnostic procedure for said code is preformed . Do you know what a diagnostic trouble chart is ? Factory service repair info. is best .
https://www.obd-codes.com/p0335

Who replaced the sensor ? You or a repair shop ? The DTC P0336 does not say to replace a sensor . You do not have access to the diagnostic trouble code diagnostic's . Your best bet ,take it to a qualified repair shop .
DTC P0336: Crankshaft Position (CKP) Sensor Performance
CKP Sensor Signal Circuit
P0335
P0335
P0335
P0336

P0336
• The ECM detects that the engine is running, but receives less than 51 or more than 65 CKP sensor pulses each engine revolution for 8 of 10 engine revolutions.
• The ECM detects that the engine is running, but more than 19 resyncs occur within 25 seconds.
• The ECM detects that the engine has been running, but the crankshaft does not sync for 0.4 second.

Here's a link on your code Jay. P0170 Fuel Trim Malfunction Bank 1 Here's a link on code P0340. https://www.obd-codes.com/p0340 Here's a link for code P0335. https://www.obd-codes.com/p0335

P0315 - Crankshaft Position System Variation Not Learned
P0335 - Magnetic Crankshaft Position Sensor Electrical Error China OBD2 car diagnostic tools wholesale on CareUCar

Nothing ever gets replaced, until you look up the
codes & then go to diagnostic charts for your vehicle

Then you component test the code items first

Codes have nothing to do with replacing anything

Study OBD2 Systems

Diagnostic Trouble Code (DTC) P0335

Magnetic Crankshaft Position Sensor Electrical Error

In this circuit DTC (data trouble code) sets when

a) The magnetic crankshaft position sensor is > 0.2V.

Or when

b) The minimum value of magnetic crankshaft position sensor is

Or when

c) The maximum value of magnetic crankshaft position sensor is higher than 2.2V.

Check this video out. Code P0725 P0335 P0340 Crankshaft Positioning Sensor Replacement DIY Nissan

Note - not a solution..just adding my woes!
I drive a 2003 Nissan Sentra SE-R Spec V.
My car suddenly stalled 1 day and the engine wouldn\'t turn over. Brought it to my mechanic and had the Camshaft position sensor replaced by my mechanic. The car ran fine for about 2 weeks and then the light was back on with the initial symptoms.

Took the car into the dealership and they diagnosed it again as P0335. Said that the mechanic hadn\'t installed the sensor correctly. Charged me a bunch of money to replace the thing and not too long ago the check engine light is on. The Revs bounce around everywhere. Checked the code again and it\'s P0335 yet again! Am in talks with the dealership to get to the bottom of this...

Hi, you can fix it by reading the article found here on P0335 - http://www.obd-codes.com/p0335