Side door was slammed too hard and now it wont open

SOURCE: Passager automatic sliding door issues

sounds like a safety trigger as in a pinch sensor or a hall sensor in the motor. does the door have a drag like feel when you open it manually or does it just zing open as it should. if it drags when u open it. i would vote motor. make sure your tracks are clean and free just lube it up with wd40

SOURCE: I can't open driver-side door from inside

You will have to take off the inner door panel and check the mechanism inside, a piece of the latch might have broken off.

SOURCE: automatic side door will no longer open with

Did these doors quit at the same time or over a period. It seems that the actuators for the locks have gone bad. With the mentioned doors, that's a lot weight for the actuators to unlock and pop open. With the remotes and console not working , that's more reason to think the actuators are the problem.

SOURCE: pt cruiser tail lights front light & driverds door wont open

The headlight, brake and turn signal all run out of the turn signal switch. this is what causing you to loose those items. the door is a clip that has broken inside the door that goes to the handle, you will have to take the door panel off to find the rod that is hanging

SOURCE: Chrysler T&C Power Door Problem

If it stops in roughly the same spot every time, and won't respond after it has stopped, it sounds like a broken wire. It is likely losing its electrical current to run the motor. It should be right where the track bends when the door has stopped. Check for loose or frayed wiring inside the flexible plastic track just below the door. The wires will often wear after being bent over and over again. If you find a broken bit of wire, cut out that section and splice in a new length of wire. Be sure you do a good job splicing, or you may end up with the same issue again soon. I am not a mechanic by any means, this just makes sense to me, and I'm considering buying an 01 town and country with this issue, which is why I'm on this site to begin with. Best of luck -