96 jeep lardeo cant use reverse what can be wrong

Did you look drive shaft to the transmission could be there?

first identify them.96 from out of what.
both a re ZJ jeeps, GC.?
the 94 has 46RH box. that engine.
the 96 has and electronic shifted box. (apples and oranges diffr)
the 96 box is a 44RE, (note the E there)
the E box needs TCM brain (part of PCM actual) to shift it.
you dont have PCM in your car that can do that.

call jeep and ask them.?
bingo.
there is more to na A/T then length and bell sizes, far more.

below is the PCM and 44re box. shift solenoids.

your 94 has nothing like this.

i found my own results to does who are having the same problem i was double check vacum hose behind the map sensor and egr valve a simple 1.50 hose did the trick

on the side of the engine halfway down ,a round dome looking thing

TPS is always located on the end of the throttle plate shaft, it is attached by two torx screws on the throttle body. The same shaft is connected to the throttle cable, through the throttle body and plate and then into the tps.

thats possiblely wrong bleed again

check the rear brakes. Possible they are out of adjustment or worn shoes.

Assuming you dont have a blown head gasket the most likely thing is a clogged radiator. Lee

If you have the 4 cylinder---- 1-3-4-2
The V6--- 1-2-3-4-5-6
left bank (driver side)--- 2-4-6
Right bank--- 1-3-5.
The in line 6 cyl.------ 1-5-6-3-2-4

what exactly does it do