1994 Ford Ranger 4.0L IAT location?

Question edited for a lot more clarity and correct name of EVAP.
Question moved to model category.

1996 Ford Ranger: location of the evap Purge Valve..cyl

JustAnswer https://www.justanswer.com > Ford Repair

Sep 14, 2008 - Hi there. its located by the battery ,,,see pics. graphic. any more info just ask , we can go back and forth on this page.

Canister purge solenoid located at on a 1994 ford ranger?
Mar 3, 2009
Ford F150 Canister Purge Solenoid Location: Q&A Guide
Oct 18, 2014
I have a 1996 Ford ranger 3.0 v6 that shows p1443 (evap ...
Jul 11, 2010
96 FORD CONTOUR GL: cly..CODE CAME..PURGE..CANISTER
Aug 23, 2007
More results from www.justanswer.com

Where does a evap sensor go in a 1996 ranger pickup

Fixya https://www.fixya.com > cars > t14417786-evap_sens...

Jul 18, 2009 - On the four, the purge solenoid and the purge flow sensor are located just aft (towards driver) of the battery on a vac line between the ...

code p 0112 refers to intake air temp (IAT) sensor --circuit malfunction===cause --wiring short to graound--wiring short to positive --IAT sensor ---ECM
code p 0117 refers to engine coolant temp (ECT) sensor--circuit malfunction=== causes --coolant thermostat---wiring short to ground--wiring short to positive ---ECT sensor
code p 0122 refers to throttle position (TP) sensor A/ accelerator pedal position (APP) sensor A low input === causes wiring short to ground--TP/APP sensor --ECM
There are 3 responses to p 0122 and all refer to TP switch /sensor plus wiring open /short to ground/ short to positive
code p 0513 refers to incorrect immobilizer key=== causes immobilizer system
code p 0556 refers to brake booster pressure sensor---circuit range / performance=== causes --wiring---poor connection---brake booster pressure sensor---ECM
code p 0565 refers to cruise control master switch. off signal --malfunction === causes wiring---cruise control master switch--ECM
by reading all the codes you will see that common causes are wiring problems and ECM so may be a quick check would be to replace the ECM with a known working unit first and work back from there

images for 94 ford ranger horn relay location and

I don't show a MAF sensor for the 4 cyl or V6 engine in a 92 model.

Get that from ATSG.Com or local
trans parts supplier, that the shops buy from

See if this helps -

94 ford ranger mass air sensor the iat sensor

can you hear the ticky ?
find that most are between left fender and steering post
some i've seen under hood in black larger fuze box

it is located on the inlet for the throttlebody on a section between the throttlebody and the air intake tube from the airbox. Do you have a North American model or a European model? The European model didn't require an IAT sensor. Just the North American model to meet EPA requirements. If it's a North Americal model, the sensor should be located in the air cleaner and have 2 small hoses attatched to it. have a good day !!

a 20 amp cb fuse is large fuse usually located in a plastic case in the engine compartment. This fuse is over 1 inch long and I believe the 20 amp is green in color and should say 20 on the top. On a Ranger it is usually located on the Driver side of the engine compartment close to the brake booster.

The iat looks like the mass air flow its a hard plastic cylinder that connects to the intake tube after the air cleaner