Rolls when in park
Parking prawl in transmission not engaging or the linkage needs adjusting to get the parking prawl pushed up far enough to engage.
Testimonial: "Thanks for tip . I will try it."
SOURCE: When braking and slowing down
rear brakes done on my 98 jeep and grinding coming from rear what can it be
SOURCE: Jeep Grand Cherokee Transmission
Absolutely, from 87 to 96 are all compatible, please don't forget to rate!!! Hope all goes well
SOURCE: 1995 Grand Jeep Cherokee
The lower speeds are controlled by a resistor block. That's what needs to be replace. It's usually located next to the blower. It will have electrical wires connected to it. High speed bypasses the block so it alway works.
If you want to replace it then;
) Disconnect the battery negative terminal if the vehicle have air bags. Wait 2 minutes for system to discharge.
) Remove the kick block on the passenger side.
)Remve the glove box
) Remove the bolts holding the blower motor resistor. Push the red lock up and press down on the click
) Pull the block out.
) Install new block and reverse steps above.
SOURCE: 1995 jeep grand Cherokee windshield wipers
the motor is bad has to be replaced the wiper delay is part of the motor .
SOURCE: 1995 jeep grand Cherokee windshield wipers will
your problem is the wiper motor its self,the park position in internal,you will need to replace the motor
713 views
Usually answered in minutes!
×