Where is the abs pump in a 2000 galant

Galant and Mirage


Fig. HCU mounting-Mirage

Fig. HCU mounting-Galant

1. Use a syringe or similar device to remove as much fluid as possible from the reservoir. Some fluid will be spilled from lines during removal of the hydraulic unit; protect adjacent painted surfaces.

1. Remove the splash shield from the left front wheel house or fender area.
2. Remove the coolant reserve tank.
3. Remove the coolant reservoir bracket.
4. Remove the dust shield from below the hydraulic unit.
5. Disconnect the brake hoses and lines from the hydraulic unit. Correct reassembly is critical. Label or identify the lines before removal. Plug each line and each port immediately after removal.
6. Remove the cover from the relay box. Disconnect the electrical harness to the hydraulic unit.
7. Remove the bolts holding the 3 mounting brackets to the vehicle; remove the unit downward and out of the vehicle.

1. Set the unit upright, supported by blocks on the workbench. The hydraulic unit must not be tilted or turned upside down. No component of the hydraulic unit should be loosened or disassembled.
2. The brackets and relays may be removed if desired.

1. Install the brackets and relays if they were removed. Tighten the bracket bolts to 16 ft. lbs. (22 Nm).
2. Install the hydraulic unit into the vehicle, keeping it upright at all times.
3. Install the retaining bolts holding the brackets to the vehicle. Tighten the bolts to 16 ft. lbs. (22 Nm).
4. Connect the hydraulic unit wiring harness.
5. Install the cover on the relay box.
6. Connect each brake line loosely to the correct port and double check the placement. Tighten each line to 10 ft. lbs. (13 Nm).
7. Fill the reservoir to the MAX line with brake fluid.
8. Bleed the brake system.
9. Install the dust shield and the coolant reserve tank with its bracket.
10. Install the fender splash shield.
11. Check ABS system function by turning the ignition ON and observing the dashboard warning lamp. Test drive the vehicle and confirm system operation