Hi there;This is for a 2000 Nissan Truck Pathfinder 4WD 3.3L SFI 6cyl
Distributor Cap & Rotor - Removal & Installation
NOTE
The 1996-00 3.3L engines were equipped with a distributor.
Disconnect the negative battery cable.
If the distributor cap is to be replaced, mark the ignition wires for identification and remove them from the distributor cap.
Remove any components necessary to access the distributor cap.
Completely loosen the distributor cap mounting fasteners.
Carefully remove the distributor cap, taking care not to damage the cap seal or rotor, then position the cap aside.
If necessary, remove the rotor retainer.
Carefully lift the rotor off the distributor shaft.
NOTE
Inspect the distributor cap to housing seal for damage and/or cracks. Replace if cracks are detected.
To install:
Install the rotor onto the distributor shaft and tighten the rotor mounting fastener, if equipped.
Position the distributor cap seal on the distributor housing, then position the distributor cap on the housing.
Install the distributor cap by tightening the mounting fasteners in a crisscross pattern. Use care to not over-tighten the fasteners.
Reconnect the spark plug wires, making sure to install them exactly in the same position from which they were removed.
Reconnect the negative battery cable.
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.
Thank you for using FixYa, have a nice day.
SOURCE: 2000 nissan pathfinder back doors will not open
Are the doors manual or auto? Are your door lock actuators engaging when you hit the open/close button? Did you check all your fuses to make sure there all good? If every thing is checking good, and the door wont open from inside or outside, then your problem is : Inside your door are a series of rods, one goes from your inner door handle straight to the door lock assembly (it is dislocated from opening the door roughly) and one goes from the actuator to the door lock assembly which I believe also is dislocated, only way to fix this problem is to weasel your way through the edge of the door panel with a very long screwdriver (16-20") and a light and try to trigger the mechanism directly on the lock to open. This is alittle tricky and might require a trained technician to perform because with the door closed your panel might not come off which will raise the risk of destroying your door panel, in the long run paying a little money could save you a lot more if you break that panel!
SOURCE: 97 nissan pathfinder cranks but wont start no spark
Did you try looking through the fuse panels or relays?
SOURCE: 2000 nissan frontier knock sensor code & distributor
no but the knock sensor does send a signal the ecm and it will ****** or advance the distributor timing
765 views
Usually answered in minutes!
×