Glove compartment stuck

To remove the glove compartment on a 2007 Lexus LS460, you will need to first open the compartment. Then, you will need to locate the mounting screws that hold the compartment in place. These screws are usually located on the sides or bottom of the compartment. Once you have found the screws, use a screwdriver to remove them. After the screws have been removed, the glove compartment should be able to be gently pulled away from the dashboard. If the compartment is stuck, you may need to carefully pry it away using a flat tool like a screwdriver or a trim panel tool. Be careful not to damage the dashboard or the glove compartment as you remove it. Once the glove compartment has been removed, you can access the area behind it for maintenance or repair.

If you look under glove box you will see two to four screws that hold the glove box on. Take out the screws and the glove box will drop down and you can get inside and release latch..then you can get a replacement latch and replace.

Presuming you are working on your air conditioner, here is a page that might help http://blog.choppedoctopus.com/2011/02/epic-project-fixing-my-ac.html. Plan on pulling you glove box and working on your head for a bit.

uder neath the glove box you should have 4 screws if not the little piston on the side has to come out and inside the glove box at the very end you should see 2 like clips that you pull out to unlock the box unit it should fall in your lap

You will need to replace the glove box door assembly. Common Volvo issue

Here are instructions on how to remove a glove box on a Honda Accord: 1. Remove these items: Dashboard center lower cover and Passenger's dashboard lower cover. 2. Remove the screws from bottom of the glove box. 3. Wrap a flat-tip screwdriver with protective tape, and apply protective tape around the related parts, to prevent damage. Insert a flat-tip screwdriver in the notch of the cap, and release the hooks by prying up the cap. 4. Remove the screws. 5. Release the hooks, then pull down on the-------------------------------------------------------------------------------------
VVDI VAG Vehicle Diagnostic

The blower motor resistor module is located behind the glove compartment, mounted to the blower motor. There is a release lever in the rear left of the glove box, push this lever to allow the glove box to drop down completely.

I had the same problem with my 2009 RAV4 lower glove box. I removed the box by popping the top front right post and then the top left front post from theside housings by prying them free with my fingers. They pop out easily. I then let the box fall open and while holding it level to the floor, pulled forward, released the piston from the post on the right, and the glove compartment came out without tools. There was a plastic electrical box cover, which came loose behind the glove box, blocking it from closing. I snapped the cover plate back in place and then reversed the glove box removal process. It took a few minutes and I needed no tools.

yes it is common on these type of cars to see if the linkage in side the glove compartment is not stuck use a screw driver and sloely pull it should get a grip then and operate perfectly

Hi, this cabin filter is not the air filter, this is the A/C filter located behind the glovebox, remove a couple of screws and a bigger nutt, and the filter is located in a vertical box.