SERVICE ENGINE LIGHT CAM ON: CODE P1320 DISPLAY ON ANYLIS WHAT IS THE SOLUTION TO FIX THIS ISSUE?
SOURCE: engine diagnostic code P1320, 2000 nissan maxima
P1320 is the Ignition Signal Primary. There is a technical bulletin for this code for this vehicle. To remedy this issue, you will need to replace all 6 ignition coils. I suggest that you purchase them from a Nissan dealer to make sure you get the right ones.
SOURCE: 2001 nissan sentra xe p1320, p1140 codes car
Distributer Signal Output is code p1320........Intake Valve Timing Control Position Sensor Bank1 is code p1140...
SOURCE: i have a 1999 nissan maxima with code P1320
This code is a crapshoot. There are two main things it could be and they are both expensive. There could be wire breakage in the engine harness. There is a thick harness coming out of engine bulkhead on the passenger/right side and it has a slight bend to it. With the engine idling grab that bend and give it a couple of twists and yanks. If the engine stumbles or misses that is the source of your troubles. If not, you more than likely need to replace the coils. Any one of the six coils could be causing the code so I recommend replacing all six at the same time. You could buy one coil for the front bank and one for the rear and swap it between cylinders to see which coil is causing the code. This is time consuming but cheaper.
SOURCE: 'service engine soon' light
HI
without using the scan tool you can do it by disconnected the the battery for ( 24 h) to reset it or to ( 5 m) to reset the service engine light but the fault sty in the memory
WITH MY BEST WISHES
3,974 views
Usually answered in minutes!
×