ABS warning light stays on after engine started
SOURCE: ABS WARNING LIGHT ON VOLVO V70 1997
ABS light comes on with ignition then should go off when you start the car.
If abs sensor does not turn off after disconnecting the battery, then
there is a real problem, a faulty sensor or ABS malfunctioning.
When the ABS led comes on immediately after you start the car and stays on usually is one of the relays.
The main one is called surge arrester relay, if it is faulty usually there have been an
overvoltage.
There should be two more, usually located behind the black plastic cover of the ABS.
Testing and changing the faulty relay can fix the problem.
If light turns off on startup, and comes back on when you reach some
speed, usually you need to check the wheel sensors. You test them
unplugging the sensor located behind the wheel and testing it for
continuity with a multimeter.
Use Haynes manual to find locations and specs of relays.
Contact a qualified mechanic if you cannot fix it yourself, problems with ABS may compromise safety of the vehicle.
SOURCE: abs warning light stays on no problems with brakes
The brakes will feel fine until u need the ABS, when the light is on the ABS is disabled. You need to have the ABS system tested for trouble codes, if the light is on there will be a code or codes.
The bearings on the wheels has to be installed one way only, the rotor ring is built into the bearing and if installed the wrong way round the sensor cant pick up the wheel speed causing the ligt to be switched on in the cluster. The diagnostic equipment should pick this up as a fault once the car has been driven, it will see the sensor when you do the diagnostic if the car is standing still but once the car is moving and no signal is send from that wheel it would register a fault into the memory of the PCM that you would be able to retrieve later.
There is a way for you to test the sensor yourself by using a multimeter set on volts, you jack the vehicle up at that wheel, install a vehicle stand to support the vehicle to be safe, disconect the wheel speed sensor and probe the two wires into the sensor, spin the wheel by hand and a small amount of current will be produced meaning the the sensor is working and the wheel bearing is installed the correct way, you can also do a continuaty test on the sensor by switching the multimeter onto ohms, but be very carefull, if this sensor has three wires you cant do the continuaty test because of the integrated circuit in the sensor, the three wire sensors opperate on a voltage from 5Volt and it would be destroyed by the multimeter opperating on 9Volt.
If the continuaty test passes and the bearing is installed the correct way, the most comon fault would be a break in the wiring leading to the PCM
Hope this will be helpfull.
SOURCE: 1999 Lincoln Navigator ABS warning light turns on?
One of the ABS sensor's is bad or a hub bearing is bad.Could be front or rear.
SOURCE: 2007 Dodge Caravan ABS light stays on after
Common issue when a wheel sensor gets faulty.On every wheel there is a sensor which informs the ABS system about wheel speed.If any of them is broken then the ABS system locks up and you get the warning light.In this case your brakes are working just as fine but you dont have ABS so wheels can block when you push the brake hard enough.Trouble code reader can tell you which one is faulty.
ABS LIGHT AND MODULE TROUBLESHOOTING:
Anti
lock brake system light comes up when there is issue with car brake systems. It
can be low brake fluid or faulty ABS fuse or its issue with brake system or assembly.
Your vehicles brake system needs inspection.
To
troubleshoot these issues, I suggest you to refer the help links provided below.
There are direct links with accurate solution, for these specific issues.
Click
the link below and follow the procedure: ------
http://howtobyme.blogspot.com/2011/11/abs-and-service-light-comes-on.html
-------------------
http://howtobyme.blogspot.com/2011/11/abs-light-stays-on-but-brakes-work-fine.html
----------------
-------------
http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html
-------------
http://howtobyme.blogspot.com/2011/11/abs-brake-lights-warning-indicator.html
-----------------------
http://whoisbyme.blogspot.in/2012/07/battery-light-and-abs-light-on-dash.html
-------------
-----------
http://technoanswers.blogspot.com/2011/11/how-anti-lock-brakes-work.html
-------------
http://technoanswers.blogspot.com/2011/11/brake-system-troubleshooting.html
-------------
http://technoanswers.blogspot.com/2012/01/anti-lock-brake-light-stays-on-all-time.html
-------------------
ABS
light comes on and Car makes Grinding noise?
http://repairhelpcenter.blogspot.com/2012/01/abs-light-comes-on-and-car-makes.html
---------------
http://repairhelpcenter.blogspot.com/2011/11/abs-trouble-codes-for-all-1994-00-acura.html
------------
http://technoanswers.blogspot.in/2012/05/2008-toyota-highlander-abs-warning.html
--------------
http://technoanswers.blogspot.in/2012/04/2003-lexus-es-vsc-trac-off-abs-lights.html
----------------
http://technoanswers.blogspot.in/2012/04/2008-toyota-highlander-hybrid-warning.html
-------------
http://schematicsdiagram.blogspot.com/2011/12/abs-brake-warning-lights-remains-steady.html
------------
http://schematicsdiagram.blogspot.in/2012/02/can-i-drive-car-without-abs-fuse.html
-----------
http://schematicsdiagram.blogspot.com/2011/12/where-is-abstcs-module-located-on-2005.html
------------------
http://schematicsdiagram.blogspot.com/2012/01/abs-motor-keeps-running.html
------------
http://howtobyme.blogspot.com/2011/12/when-car-stopsabs-pump-turns-on.html
-----------
http://technoanswers.blogspot.in/2012/02/replacing-abs-unit-on-buick-century.html
----------------
--------------
http://technoanswers.blogspot.in/2012/04/toyota-camry-premature-abs-actuation.html
-----------
How to replace ABS Modulator Control
Unit on Acura Integra?
http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-abs-modulator-control.html
----------------
How to replace ABS Pump Assembly on
Acura Integra?
http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-abs-pump-assembly-on.html
-----------
How to remove ABS Accumulator on
Acura Integra?
http://repairhelpcenter.blogspot.in/2011/11/how-to-remove-abs-accumulator-on-acura.html
---------
How to remove ABS Control Unit on
Acura Integra?
http://repairhelpcenter.blogspot.in/2011/11/how-to-remove-abs-control-unit-on-acura.html
------------
These details will help.
Thanks.
On vehicles equipped with antilock brakes (ABS), a second warning light is provided to warn if a problem occurs within the ABS system. The ABS lamp comes on when the ignition is turned on for a bulb check, then goes out after the engine starts. If the ABS warning light remains on or comes on while driving, it indicates a fault has occurred in the ABS system.
What happens next depends on the nature of the fault. On most applications, the ABS system disables itself if the ABS warning light comes on and remains on.
765 views
Usually answered in minutes!
×