Yes, it can be the relay. What I do is unplug the relay and swap it gor yhe horn relay. If this doesn't work, I use a volt/ohmmeter to probe the relay socket. Doing this, I can usually find the problem. With the key on , there should be two terminals in the socket that have battery voltage and one that is grounded. The last terminal goes to the pump and should show low ohms to ground. In your truck, the relay coil is connected to ground and turned on by the ecm with a positive signal. It also seems to depend on the oil pressure switch, so you might want to temporarily bypass the switch with a paper clip in the connector to see if that is keeeping the pump from running.
SOURCE: 1993 chevy corsica 3.1 engine 6 cylinder. starts
are you getting a rotten egg smell? try disconnecting the exhaust and see if it stays running. if it does replace the cat. convertor
SOURCE: 1997 chevy silverado 1500 350 vortech, new fule pump not working
before you drop tank again, check fuses & relay.then disconnect fuel line @ filter turn key to on position should hear fuel pump run and get gas stream out of line. if no flow from line new pump faulty be sure & remove negative battery cable first good luck.
SOURCE: my 1996 chevy silverado 1500 4x4 5.0 is running
also check your fuel flow rate u can havegood pressure but not enough flow and make sureu dnt have water in the fuel
SOURCE: i have a 1993 chevy 1500 4x4,with a 4.3 engine,and
Chech the ground on the pump from wire harness from tank....they get old and lose the capacity to ground ....also check for power at the tank with a circuit tester....if no power...you have wiring issues...
SOURCE: I have no power at the feul pump on a 1999 Chevy
Check the fuel pump relay. Refer to the owners manual for it's location.
156 views
Usually answered in minutes!
×