Codes P0562,P1081,P0455(EVA)
SOURCE: 1999 volvo radio code
To reset the radio you have to leave the key in position one (the radio will come on, but the dash lights are not on) with the radio on for at least two hours. It can take up to four hours to reset.
Make sure the climate control and blower are in the off position to keep the battery from running down. Eventually the radio will say "code". There is a four digit code that is unique to each radio, if you don't have it you must contact the local Volvo dealer and have your VIN code. The VIN code is locate on the far top/right side of the dash, you must be outside the car to see it. It will begin with something like YV1LS...................
When you get this code from the dealer you input the code using the radio preset (1-6 buttons). If the radio says code again that means it is the incorrect radio code. Most likely the radio has been replaced. Then it would be alot easier to take it to the dealer since the radio has to be removed and the serial number taken off the radio chassis unit. Usually most dealers will do it for free if they think you'll come back for services, so just tell them you just bought it and be nice, hopefully it will work.
hope this helps
SOURCE: 1999 volvo s70 will not start sometime after door unlock
Try to check the battery and the alternator and the fuse make sure the battery connector is not loose.
I’m happy to assist further over the phone at https://www.6ya.com/expert/ramy_d9e7ebea3891f482
SOURCE: code p0455 on volvo s70
P0455 OBD-II - Evaporative Emission Control System Leak Detected (no purge flow or large leak)
This indicates a fuel vapor leak or lack of purge flow in the EVAP control system. It means a large leak has been detected. The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage. Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.
Symptoms: You likely won't notice any drivability problems.
Causes: A code p0455 most likely means one or more of the following has happened:
A loose or improperly affixed gas cap
A non-conforming gas cap (i.e. not factory/original brand)
Other leak or damaged piece in EVAP system
Possible Solutions: With a p0455, the most common repair is to:
Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back.
Otherwise, replace the gas cap, and/or
Inspect the EVAP system for cuts/holes in tubes/hoses (you may hear a vacuum noise or smell fuel), repair if necessary
Hope this helps (remember to rate and comment this answer).
47 views
Usually answered in minutes!
×