2002 Jaguar X-Type Logo
Andrew Simpson Posted on May 29, 2012

Jaguar x-type key locks & unlocks doors, remote functions work, turns ignition on but wont start the car

The kep fob functions work, key turns ignition on but won't go to position 3 to start the engine.

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Night Owl:

An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Contributor 43 Answers
  • Posted on May 30, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Night Owl:

An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

Joined: May 27, 2012
Answers
43
Questions
0
Helped
15427
Points
59

Might be some obstruction in the lock cylinder itself.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Apr 16, 2009

SOURCE: remote key fob stopped working not battery

try reprogramming.process widely available on these sites. 're-programming x-type key fobs'

Ad

SPEEDY CAR WORK SHOP

  • 489 Answers
  • Posted on Aug 13, 2009

SOURCE: key fob wont open doors or boot or lock them

you need to reprogram keys with the module. there could be a problem with the module though , you need to check it out

raygin

Raygin

  • 322 Answers
  • Posted on Apr 07, 2009

SOURCE: How do I program S Type Jaguar key fob Year 2000 Jag ?

Seperate key fobs only can be programmed in the following way.

Turn ignition on/off 8 x times (allow all functions to stabilise) after the 9th on - press a button on both remote fobs. then turn ign. off. use good remote to lock and then try new remote to unlock/lock. sometimes it works first time - sometimes you have to repeat actions. good luck.

raygin

Raygin

  • 322 Answers
  • Posted on Jul 08, 2009

SOURCE: Jag S-Type -intermitent fault where the remote fob does not work

This does not sound like a fob fault - but a locking control module fault , either in the hardware or software of the unit. Get it checked at a Jaguar dealers. When unlocking using the key - as soon as the door is opened you should hear a chime sounding inside the car - this is a timer counting down to sounding the alarm. If you put your key in the ignition as soon as you open the door the alarm should not go off and the chime should stop. If it does not this again points to a fault in the locking controller.
hope this helps - good luck.

roy08

  • 1 Answer
  • Posted on Aug 03, 2009

SOURCE: my jaguar x-type 04, remote lock does not work,

Hi,

I have a similar problem in my x type. Although if I press unlock button on the key first and then use the metalic key to unlock it dissables the alarm.

Also according to the manual if you unlock by the metalic key the car starts a beeping sound its I think 15-20 second timer within which you should put the key and start the ignition (don't need to start the engin) this will dissarm the alarm if not the alarm will go off in 15-20 second.

Hope this information is of any use, am trying to get hold of Jaguar dealers to fix this issue. If you come accross any solution please do let me know too

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Kiah sportage 1999 remote wont unlock my ignition to get my motor going,i have changed the battery but still doesnt start,,is there any way to bypass the remote to get my car going.

keys into ignition turn to number 2. press fob. doors lock press again doors unlock. turn ignition back remove key. press fob lock doors wait 5 seconds press fob to open doors. then try ignition again. should work. if not then there is something like a chip missing from the key or the ring reader on the ignition is not working.
1helpful
1answer

How do I reprogram s type jaguar key fob year 2002 jag

Seperate key fobs only can be programmed in the following way.

Turn ignition on/off 8 x times (allow all functions to stabilise) after the 9th on - press a button on both remote fobs. then turn ign. off. use good remote to lock and then try new remote to unlock/lock. sometimes it works first time - sometimes you have to repeat actions. good luck.
0helpful
1answer

My lock and boot button does not work on my key fob

My remote would not work for any function. Took it appart and cleaned the circut board with alcohol and now everything works.
0helpful
1answer

Vehicle wont start

what type of vehicle?
5helpful
1answer

How can I reprogram my Jaguar X Type Key so I can unlock and lock my doors?

if your just programming the fob to the module and it has not been replaced and your just needing a manual reset,then follow the folowing procedure:

1 Insert key into ignition
2 Turn key to 'I"
3 Turn key "II" and back to 'I' quickly 4 times
4 Alarm system will chime once when key is back to 'I' for the
fourth time
5 Remove key from ignition
6 Press any button on each key fob and alarm system will chime
for each fob if it has been programmed correctly
7 Press unlock/lock/trunk etc to make sure everything works
8helpful
1answer

My renault laguna 1999 rt remote key fob wont work?

IF YOU TYPE 1999 RENAULT LAGUNA REPROGRAMME KEY INTO A GOOGLE SEARCH, YOU WILL BE ABLE TO PRINTOFF INSTRUCTIONS TO REPROGRAMME THE KEY TO THE KEY READER.THE IGNITION NEEDS TO BE OFF TO DO THIS
4helpful
2answers

Jag S-Type -intermitent fault where the remote fob does not work

This does not sound like a fob fault - but a locking control module fault , either in the hardware or software of the unit. Get it checked at a Jaguar dealers. When unlocking using the key - as soon as the door is opened you should hear a chime sounding inside the car - this is a timer counting down to sounding the alarm. If you put your key in the ignition as soon as you open the door the alarm should not go off and the chime should stop. If it does not this again points to a fault in the locking controller.
hope this helps - good luck.
4helpful
2answers

Car security system do not respond to remote(new battery)

hi,when you remove the key from the ignition,does the little flap in the barrell flip down?.if not the key fob wont work.it thinks the key is still in the barrell.after a tiny bit of wd40 on the key it was ok.it pickled me head for ages.maybe its that. paul
16helpful
3answers

How do I program S Type Jaguar key fob Year 2000 Jag ?

Seperate key fobs only can be programmed in the following way.

Turn ignition on/off 8 x times (allow all functions to stabilise) after the 9th on - press a button on both remote fobs. then turn ign. off. use good remote to lock and then try new remote to unlock/lock. sometimes it works first time - sometimes you have to repeat actions. good luck.
37helpful
4answers

Program a remote key for 03 A6

I have an A4 and did this to re-program my key:

1. used the key to start the car...then turned it off
2. put the key in the driver door (door closed)
3. pressed the lock button on the key fob once
4. turned the key to lock the door.

This is basically the steps in the owners manual, but the car must be started with the key first, and the key must be in the door lock before pressing the lock button.
Not finding what you are looking for?

672 views

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...