The old remote stopped working so we have purchased a new one and now need to program it
If it is a 2003 model year vehicle follow this procedure. If it doesn't work, you may have the wrong fob which happens all the time.
Sit in vehicle and close all doors.
COMPLETELY insert and remove ignition key more than six times within 10 seconds.
Hazard lights should flash twice.
Turn ignition to ACC position
Press and hold any button on the new key fob hazard lights will flash twice
For a second key fob using the master lock switch, lock and unlock the doors then hold down any button on the second remote until the hazard lamps flash twice.
Then you are done open the door to exit the programming mode.
If the lamps didn't flash when holding down the key fob make sure you have the right key fob, they are different for each car.
The parts store were I purchased the new remotes programmed them with their computer and. Still didn't work. I checked. The fuses. And all were good. Is there a receiver in the dash that could. Go bad?
×
4,330 views
Usually answered in minutes!
it is a 2003 model nissan pulsar
What model and year is the car, not a 1990 nissan Pulsar I assume?
need to program new remote
×