Looking for an image of where the MAP sensor is located on a 2001 Jeep Grand Cherokee
SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
SOURCE: where is the map sensor located? 1994 jeep grand cherokee
Go half way between the air cleaner box and the "carburetor". Up the 4" black air pipe, a wire harness plug plugs into the MAP sensor there. Also called MAS air flow sensor.
SOURCE: I have 2001 jeep grand cherokee 6cyl need
On the top of the bellhousing. From the drivers point of view it is in the 11:00 o'clock position. The harness wraps around the back of the bellhousing and plugs in on the passenger side of the block near the oil sending unit.
SOURCE: location of tps and map sensor on a 02 jeep grand cherokee 4.7l
Both are attached to the throttle body. Tps is on the other end of the throttle plate shaft opposite the linkage, MAP is on the side...has small vacuum hose underneath and is flat, about 3" long. The other item on the TB is the idle air motor, next to tps.
SOURCE: where is the MAP sensor
ITS INTHE INTAKE MANIFOLD MAP STANDS FOR MANIFOLD ABSOLITE PRESSURE THE SERVICE CODE SHOULD BE PO1106 HIGH VOLTAGE OR PO1107 LOW VOLTAGE IF YOU DON;T HAVE THESE CODES THEN ITS PROBELY NOT THE MAP SENSOR REPLACING COMPOUNETS SHOULD BE THE LAST STEP FORM A PLAIN IM NOT SAYING MAP IS NOT THE PROBLEM BUT BLINDLY REPLACEING SENSORS CAN BE A COSELY MISTAKE GET CODES
4,973 views
Usually answered in minutes!
×